Examples of 'metal thickness' in a sentence
Meaning of "metal thickness"
metal thickness - the measurement of how thick a piece of metal is, usually relevant in industrial or construction settings
How to use "metal thickness" in a sentence
Basic
Advanced
metal thickness
Metal thickness is measured both optically and electrically.
The flushness effect is independent of the metal thickness.
Metal thickness is generally not a factor in determining good welds.
No discolouration of the print occurred at this increased metal thickness.
The same metal thickness has been taken in either case.
We produce high precision parts from various materials up to a metal thickness.
Increasing the metal thickness would result in increased material costs.
Thus the welds do not cover the whole sheet metal thickness.
The variations in metal thickness are produced whilst manufacturing the block by electroforming.
It is also possible to input the minimum radius for each metal thickness.
The ability to maintain the same metal thickness before and after embossing.
This innovative feature uses a single backwall echo to measure true metal thickness.
Theoretically, with any of these procedures, the metal thickness is changed in its composition.
The use of such blocks avoids machining and grinding blocks having a solid metal thickness.
However, plasma can cut through greater metal thickness than most industrial lasers.
See also
The metal thickness to be deposited is therefore given by the following formula, EPMATHMARKEREP.
Figure 7 is a graph of percentage transmission vs silver metal thickness and emissivity.
Metal thickness 3mm. Material is black steel. Painted with red colour.
Second, select a plasma cutter that cuts the metal thickness you will be cutting most often.
The sheet metal thickness D of the rail 3 is also illustrated in this FIG . 2 d.
The remaining walls of this switch cabinet housing have a sheet metal thickness of 1 to 1.5 mm.
Minimum base metal thickness is 95 % of design thickness.
In Table 1 % elongation was used as a measure of metal thickness reduction.
Sheet metal thickness of contact element 13.
When dealing with frequencies below 30 MHz, the metal thickness affects shielding effectiveness.
Metal thickness measuring through surface coating ( e.g. paint ) in A-Scan mode.
Example 1 A roll of polyester was vacuum-metallised with aluminium to a metal thickness of approximately 30 nm.
In one embodiment, the immersion plated metal thickness ranges from about 0.1 µm to about 3 µm.
Example 1 A roll of polyester is vacuum-metallised with aluminium to a metal thickness of approximately 30nm.
The sheet is generally metallized to a metal thickness of between 75 to 300 Angstroms.
You'll also be interested in:
Examples of using Metal
Show more
But there is metal in the electrolyte regulators
It sounds like a wheelchair going down a metal staircase
Plastic or metal foil vent is not recommended
Examples of using Thickness
Show more
Minimum recommended thickness of zinc vs thickness of steel
Thickness of tanks made with double walls
Reduction of wall thickness and additional protection
