Examples of 'ml of aqueous' in a sentence
Meaning of "ml of aqueous"
ml of aqueous - refers to a volume measurement of a liquid solution that contains water as the solvent, commonly used in chemistry and medicine
How to use "ml of aqueous" in a sentence
Basic
Advanced
ml of aqueous
Drain off a few mL of aqueous phase to rinse stop cock and funnel tip.
Each of the reservoirs can hold 6 ml of aqueous fluid.
Ml of aqueous solution containing 39 weight % lithium chloride was prepared.
The product eluted sharply in the first 5 mL of aqueous isopropanol.
A total of about 80 ml of aqueous ammonia was obtained over approximately 4 hours.
Five hundred and thirty-eight microliters of absolute ethanol was added per 1 ml of aqueous layer.
The pellet was resuspended in 5 mL of aqueous ethanol to a final volume of 40 mL.
The resultant mixture was stirred with 20 ml of aqueous HCl.
Reduction was completed by adding 50 ml of aqueous solution containing 25 g of sodium hypophosphite.
The obtained mixture was dropwise added to 30 ml of aqueous ammonia.
Each sprayer containing 0.1 mL of aqueous solution for intranasal administration contains 2 mg of naloxone.
To the organic solvent-treated test material was added 10 ml of aqueous buffer.
The stirring was stopped and 40 ml of aqueous layer was removed by suction.
The lenses are then placed in the carrying case containing 7.5 ml of aqueous liquid.
To this reaction mixture was added 1 ml of aqueous ammonia, followed by stirring for 20 minutes.
See also
The crystalline hydrochloride was filtered off and taken up with 200 ml of aqueous ammonia.
Additional 0.2 mL of aqueous ammonium was added and the resulting mixture was stirred overnight.
The reaction mixture was quenched by adding 10 mL of aqueous potassium sodium tartarate.
One hundred ( 100 ) mL of aqueous bicarbonate concentrate solution was added to each test article.
The reaction was poured into 2 mL of aqueous saturated NaHCO3.
Then 1 ml of aqueous 1 molar solution of HNO3 is added.
Therefore, convenient ampoules containing 1 to 10 mL of aqueous solution may be prepared.
This was mixed with 0.1 ml of aqueous ammonia and extracted with 2 ml of chloroform.
The resin was then filtered, and washed with 4 ml of aqueous acetic acid.
After 4 hours at rest 700 ml of aqueous phase are unloaded from the bottom tap.
The mixture was stirred 1.5 hours and concentrated until approximately 1 ml of aqueous solution was remaining.
The mixture was then poured into 75 ml of aqueous ammonium hydroxide solution.
The reaction was quenched by pouring into 50 mL of aqueous NaHCO3.
Prior to spraying the drug solution, 50 mL of aqueous solution was added to this precipitator.
The combined mixture is hydrolyzed with 50 ml of ice and 30 ml of aqueous ammonia.
Hydration was carried out with 1 ml of aqueous solution per 50 » mole phospholipid.
At 40°C, the undiluted samples both released approximately 2 ml of aqueous phase.
The solvents were evaporated, 15 mL of aqueous 1M HCl solution was added.
The solid was collected by filtration, and dissolved in 250 mL of aqueous 2 N NaOH solution.
The reaction solution was poured into 100 ml of aqueous solution of 2N hydrochloric acid in anice-bath.
Of the compound of Example 4 is dissolved in 2 ml of aqueous 3N HCl solution.
Typically, from 2 to 5 ml, preferably about 3 ½ ml of aqueous solution or suspension is used.
After this time the reaction mixture was poured into 500 mL of aqueous 10 % ammonium chloride.
A total of 190 ml of organic layer and 60 ml of aqueous layer of distillate were collected.
The contents of the flask were diluted with 30 mL of aqueous mL of ethyl acetate.
To this mixture was added 32 ml of aqueous 6N sodium hydroxide.
Preferred methods involve adding 1 drop ( approximately 30 µL ) to 5 mL of aqueous solvent or disinfecting solution.
The resulting mixture was washed with 20 mL of aqueous potassium carbonate.
Next day the chips were dried and the washed with 1 ml of aqueous 50 % urea solution.
The reaction was quenched at -78 °C by addition of 20 mL of aqueous saturated ammonium chloride solution.
The reaction solution was filtered, and then 1.2 ml of aqueous 5N hydrochloric acid was added.
To the resulting two-phase mixture was added 180 mL of aqueous 1M LiOH in two aliquots.
The organic phases were combined and extracted three times with 20 ml of aqueous 0.5N hydrochloric acid.
You'll also be interested in:
Examples of using Ml
Show more
One ml of saliva carries more germs than
Your doctor will prescribe the dose in ml
Six to eight ml of hydrogen peroxide will be necessary
Examples of using Aqueous
Show more
Aqueous suspension filled into the box
Not restricted aqueous solution very low
In aqueous solution potassium lye or liquid potassium
