Examples of 'no-load speed' in a sentence
Meaning of "no-load speed"
In engineering or mechanics, the term 'no-load speed' refers to the speed at which a motor or engine operates when there is no load or resistance applied to it. It is often used to determine the efficiency and performance of the motor or engine
How to use "no-load speed" in a sentence
Basic
Advanced
no-load speed
Adjusting no-load speed and revolution angle.
The saw disc must be suitable for the no-load speed.
The no-load speed of the electric motor varies by model and specification.
The saw blade must be suitable for the no-load speed.
Greater than the no-load speed of the tool specifi ed on the nameplate.
Only use tools that are suited to the no-load speed of your machine.
This higher no-load speed produces undesirable increases in tool wear and noise.
Only use router bits suitable for the no-load speed of the tool.
The no-load speed of the electric motor varies by model and speci! cation.
Wheel and run the power tool at maximum no-load speed for one minute.
This feature gradually increases the motor speed up from zero to the top no-load speed.
U Voltage of battery pack n No-load speed Tightening torque for screwing.
The RPM value of a motor that will be specified will normally be the no-load speed.
Run the tool at full no-load speed for 5 minutes to seat the brushes.
Never fit any attachment with a maximum speed lower than the no-load speed of the machine.
See also
Maximum no-load speed.
U Voltage of battery pack n No-load speed.
Read instruction manual! n0 Design no-load speed Observe caution and safety notes!
A speed that is at least as high as the product 's maximum no-load speed.
U battery-pack voltage n no-load speed.
Min-1 Revolutions or motions per minute No-load speed.
You'll also be interested in:
Examples of using No-load
Show more
Adjusting no-load speed and revolution angle
Never operate the appliance in a no-load condition
The no-load current is speed and temperature depend t
Examples of using Speed
Show more
The speed of the vacuum source shall be
I must have hit speed dial by mistake
Zoom speed is determined by the amount of rotation
