Examples of 'nut and washer' in a sentence
Meaning of "nut and washer"
nut and washer - This phrase typically refers to the combination of a nut and washer used in fastening bolts or screws. It indicates the specific hardware components needed for secure and stable assembly
How to use "nut and washer" in a sentence
Basic
Advanced
nut and washer
Hex nut and washer located behind tire.
Do not adjust the inner nut and washer.
Remove nut and washer from starter post.
Rod come complete with nut and washer.
Remove hex nut and washer from bottom of belt guard.
Lock washer and remove the nut and washer.
Temporarily remove nut and washer from center carriage bolt.
Mount the adjustment bolt with the nut and washer.
Remove the nut and washer from the drip tray.
This fastener also suggests only a separable nut and washer.
The nut and washer thickness is equal to the nominal thread diameter.
Remove the filter cover by unscrewing the wing nut and washer.
Remove the wing nut and washer from the cutting head shield.
Replace and t ighten the remaining screws and the nut and washer.
Take the nut and washer off the other end of the screw.
See also
The standard bolting flat surface nut and washer interfaz is changed.
Reinstall nut and washer and tighten by again holding the shaft stationary.
Is you did not slip the trap nut and washer onto the tailpiece.
Pull out the split pin and remove the propeller nut and washer.
The propeller is secured using the nut and washer provided with the spinner.
Hold the unit and hang it on the hanging rod with the nut and washer.
Nut and Washer.
Remove the split pin, propeller nut and washer.
Pre-assembled nut and washer allow faster installation.
Expandet Threaded Rod pointed, with nut and washer.
Re-install the impellor shaft nut and washer on the right hand side, and tighten.
The nut and washer assemblies are included with the Quick DC-Link module.
It is secured in place with a nut and washer on either side Figure 4.
These perimetral grub screws ( 11 ) also have locking nut and washer.
Remove pre-assembled wing nut and washer from temperature gauge C.
Have a second person install a rack-mount screw-and cage nut and washer if your.
Expander System - Nut and Washer Applications with no obstacles around the pivot joint Read more.
FIGURE 3 is an exploded perspective view of a nut and washer in position to be assembled ;.
Remove 1/2 ″ nut and washer from the shaft and replace the brush.
They consist of a stud, nut and washer.
To remove the device, the nut and washer are removed, and the through-shaft is withdrawn.
FIGURE 3 is a sectional view showing the nut and washer assembly ;.
Take off the screw nut and washer on Seat Pad ( N ) and set aside.
Products Kuppielevaattorit Set of screws, nut and washer for bucket M7x20.
Remove the nut and washer ( F ) to remove the fan ( G ) and motor shaft adapter H.
You'll also be interested in:
Examples of using Nut
Show more
I am kind of a hard nut to crack in that department
A nut who knows a lot about bombs
Loosen the bottom nut to eliminate water
Examples of using Washer
Show more
Insert washer and thread nut to screw
The following is a guide to using your washer
This pressure washer is designed for cold
