Examples of 'o-ring' in a sentence
Meaning of "o-ring"
o-ring (noun) - A torus-shaped mechanical gasket designed to seal connections in various industrial and automotive applications, often used to prevent leaks in pipes, fittings, and hydraulic systems
Show more definitions
- A circular gasket, usually made of rubber.
How to use "o-ring" in a sentence
Basic
Advanced
o-ring
Install a new o-ring if necessary to stop leaks.
Use silicone grease to lubricate the O-Ring.
Lubricate o-ring with a silicone based lubricant.
Check stem to make sure o-ring is present.
Lubricate o-ring and install onto diffuser.
Aluminium manifold mounting spacer o-ring seal.
Replace o-ring seal if there is visible damage.
Check for compatibility or simply replace the o-ring.
O-ring on the valve is dry after disassembly.
Install a new o-ring and apply grease to it.
O-ring lubricant or grease is not required on waterproof seals.
The ends of the o-ring do not have to be welded.
O-ring needs to be replaced and lubricated.
Check the valve o-ring for cuts or deterioration.
O-ring forgotten in the diaphragm piston during assembly.
See also
Needle assembly o-ring damaged or missing.
The o-ring helps to keep your pump waterproof.
The pressure chamber o-ring can also be replaced.
Worn O-Ring on piston or lack of lubrication.
Be very carefull when you install this o-ring.
Replace the o-ring on to the cylinder head.
These are located directly in front of the O-Ring gasket.
Remove the o-ring using a flat head screwdriver.
Some chemicals will damage the o-ring material.
Make certain O-Ring is seated level in the groove.
Packing nut can be tightened without o-ring removal.
Install new o-ring seal onto strain relief.
Carefully remove and replace o-ring from piston.
Lubricate o-ring with a silicone based lubricant or water.
Cutter assembly pivot tube o-ring damaged or missing.
O-ring shall be loosely fitted in the valve body.
Refer to important o-ring care instructions in this manual.
O-ring in trigger valve head is worn and damaged.
Apply grease to the new o-ring and install it.
O-ring on the small piston is worn and damaged.
Use care to avoid damaging the outer o-ring.
Clean o-ring with a soft clean cloth to insure.
Retention of the glove on the ring is achieved by an o-ring.
Need an O-Ring seal in a specific material.
The pressure seals may each comprise an o-ring.
Replace o-ring retaining screw and tighten firmly.
Clean and lightly lubricate O-Ring with silicone lubricant.
Install o-ring and sediment cup with cap screw.
Reinstall the plastic shroud and replace the o-ring.
Make sure the o-ring is completely installed in the groove.
Blind lid in painted aluminum with silicone o-ring seal.
The original equipment O-Ring contains a permanent internal lubricant.
Apply a liberal amount of grease to the compression piston o-ring.
Make sure the o-ring is fully seated in the slot.
Wind lid by one quarter of a turn to seal on the o-ring.
