Examples of 'o-rings' in a sentence
Meaning of "o-rings"
o-ring (noun)", "definition": "An O-ring is a loop of elastomer with a round cross-section, used as a mechanical gasket or seal. In English, 'O-ring' may refer to the specific type of seal or be used more generally to describe a sealing ring with a circular shape.
Show more definitions
- plural of O-ring
How to use "o-rings" in a sentence
Basic
Advanced
o-rings
O-rings designed for high differential pressures.
Do not pull the rubber o-rings excessively.
O-rings are exactly as expected and received on time.
We use a good quality o-rings to prevent water leakage.
O-rings are used when operating at high temperature.
Remove the protective cover from the o-rings.
O-rings are complete and are functioning properly.
Special fixtures are available for testing elastomeric o-rings.
O-rings are delivered with the accumulator.
Take care to ensure that the o-rings are still in position.
O-rings and sealing surfaces must be perfectly clean.
Check and replace any damaged o-rings and seals.
Install new o-rings and apply grease to them.
These kits will have seals and suitable o-rings.
Replace any o-rings that show signs of wear.
See also
The autoclave was finally vented and the o-rings recovered.
Gaskets and O-Rings in specialized materials.
Do not spray isopropyl alcohol on the cam when o-rings are installed.
Ensure o-rings are liberally coated with a silicone based lubricant.
Check and change all worn or damaged o-rings and seals.
O-rings throttle valve dislodged from seat inlet valve.
Carefully install all o-rings into unions and hand tighten.
O-rings are the most frequent type of these sealing rings.
Install new caliper o-rings onto the outboard caliper half.
O-rings are shown and ensure the sealing of the hydraulic assembly.
Took apart replaced o-rings and back together in about an hour.
O-rings are fabricated specially to be able to withstand serious temperature and pressure.
Not until they get the darn o-rings straightened out.
Lubrication of o-rings is extremely important for installation and operation.
Other known devices utilize one or more o-rings to accomplish a seal.
Lubricate the O-Rings first we recommend using silicone lubricant.
Use your fingers to install the new o-rings and scraper seal.
Lubricate the o-rings on the exterior of the packings with grease.
Apply grease to the positive and negative air pistons and o-rings.
All necessary o-rings are bundled and shipped in the accessories bag.
Use your fingers or a pick to remove the outer seal head o-rings.
Install new o-rings onto the top cap and piston.
Refer to the instruction sheet provided in the kit to service your unit 's o-rings.
There are just o-rings sealing them in the water pump.
Ers contain chemicals which could seriously damage plastic parts and o-rings.
Isopropyl alcohol can cause the o-rings to become brittle and break.
O-rings and seals can be wiped clean but not be soaked in solvent.
Remove cassette and inspect o-rings to make sure they are in place and clean.
O-rings must be replaced and tap stems lubricated with appropriate grease.
Remove both of the caliper o-rings from the outboard side of the caliper.
O-rings are mainly used for static seals and reciprocating motion seals.
Apply grease to the new o-rings and install them on the seal head.
These o-rings are made of a resilient polymer material which is substantially non-conductive.
Casing has a right hand thread on both ends and is sealed with O-Rings.
Remove the o-rings from the banjo bolt and banjo fitting.
