Examples of 'ohmmeter' in a sentence
Meaning of "ohmmeter"
ohmmeter (noun) - A device used to measure electrical resistance in ohms, often part of a multimeter or dedicated instrument. An ohmmeter is employed in electronics, electrical engineering, and troubleshooting circuits to determine resistance levels and diagnose faults or malfunctions
Show more definitions
- A portable device for measuring relatively small values of electrical resistance.
How to use "ohmmeter" in a sentence
Basic
Advanced
ohmmeter
Never ever connect an ohmmeter to a live circuit.
But an ohmmeter shows that it is an open circuit.
Test assembly with an ohmmeter before proceeding.
Use an ohmmeter to verify correct resistance on each element.
Very easy to test for this with an ohmmeter.
Using an ohmmeter to check for premature element failure.
Injector resistance can be measured directly with an ohmmeter.
Resistance with an ohmmeter will indicate a short circuit.
What you can not check with ohmmeter.
The type of ohmmeter thus described has a disadvantage.
Remove the heater and test it with an ohmmeter.
A ohmmeter or some sort of continuity tester.
The device may be a simple ohmmeter.
Use an ohmmeter to check for continuity across suspected connections.
So you would only need a voltmeter and an ohmmeter.
See also
Use ohmmeter to check electronic cells for short circuits.
Measure its resistance with an ohmmeter.
With an ohmmeter check whether the circuit between the.
The two remaining contact points are connected to an ohmmeter.
This type of ohmmeter suffers from two inherent disadvantages.
Remove and test with an ohmmeter.
The ohmmeter will indieate an infinitely high value of resistanee.
Put the probes of your ohmmeter on the two ends.
An ohmmeter would detect any intrusion into the conduit.
Frank gets the ohmmeter.
Method and ohmmeter for measuring very low electric resistances.
Check the resistance with an ohmmeter if you have one.
On the latter also appears the battery of the ohmmeter.
Use ohmmeter to check continuity from brass brush holder to brush holder.
The stator must be dried out and then rechecked on the ohmmeter.
Our handy ohmmeter measures the resistance lower than that of a ribbon.
Remove the connector or power wires and test them using a multimeter set to ohmmeter.
This allows the ohmmeter to ignore the resistance of the first pair of terminals.
This step can also include obtaining the resistance of the path using an ohmmeter.
A simple ohmmeter allows checking both of the circuit and of the presence of condensation.
Switch and combination TPS are tested with an ohmmeter.
You can connect an ohmmeter to a photoresistor to see how its resistance changes with light.
This determines the resistance of the column in the Ohmmeter.
Ohmmeter An instrument that measures electrical resistance.
Testing the LED with an analog Ohmmeter.
Ohmmeter Firing cable and reel.
Place the selector switch on the ohmmeter function Ω Automatic range selection.
An ohmmeter connected between T and ground on the CO side reads a very high resistance.
If open, locate exact place using ohmmeter.
The ohmmeter rating should be below 2 ohms.
Use a four-terminal ohmmeter for greater accuracy.
If an ohmmeter indicates no resistance or infinite resistance, the motor is probably damaged.
The multimeter combines the functions of a voltmeter, ammeter and ohmmeter.
If the ohmmeter indicates an open circuit, perform the following.
If the electronics then work properly, the annunciator must be tested with an ohmmeter.
