Examples of 'ohms' in a sentence
Meaning of "ohms"
ohm (noun) - a unit of electrical resistance, often used in scientific or technical discussions related to electricity and circuits
Show more definitions
- Initialism of On Her Majesty's/His Majesty's Service.
- plural of ohm
How to use "ohms" in a sentence
Basic
Advanced
ohms
Ohms are used to measure the resistance of electricity.
The reading should indicate low ohms.
Slight variations of a few ohms are not critical.
Out of the box before installation ohms.
It is here reported in ohms per square units.
This resistance is measured in units called ohms.
Checked the ohms on the coil.
And the resistance is in the units of ohms.
Set a digital multimeter to ohms in order to measure resistance.
The effectiveness of a given resistor is measured in ohms.
Ohms are used for measuring the resistance of electricity.
Set the multimeter to read mega ohms.
Volts divided by ohms equal to amps.
Set your digital multimeter to read ohms.
A good fuse will have zero ohms of resistance.
See also
Both impedance and resistance are measured in ohms.
Their individual resistances in ohms do not simply add.
It is a combination of resistance and reactance and is measured in ohms.
Resistance is reported as ohms per square.
The amount of resistance a resistor provides is measured in ohms.
The values of resistors are in ohms unless otherwise indicated.
The base epsilon criteria is two ohms.
The ohms measurement must be recorded in your warranty card.
After floor coverings are installed ohms.
Note the resistance in ohms that appears on the screen.
After cable and sensor are fastened to floor ohms.
The difference in ohms can make a large difference in power.
Re gonna end our class with three ohms.
Minimum impedances in ohms are given together with the corresponding frequency.
Two hundred and twenty volts at eight ohms.
Ohms may be selected for direct drive low impedance systems.
They should see zero ohms.
The total resistance in ohms should be written on the side or bottom.
Explain that resistance is measured in units called ohms.
Ohms and so forth.
Their value is usually equal to a few thousand ohms.
Ohms and watts.
All of these readings are shown in ohms.
Applying ohms law.
Previously should now read close to zero ohms.
Ohms or more.
Its internal resistance in ohms will be.
Ohms or less.
Speaker strength is in watts and ohms.
Note the resistance value in ohms is equal to volts divided by current in amps.
Provides water quality over one million ohms.
Resistance is measured in ohms and refers to the resistance to flow of electric current.
It should read close to zero ohms.
Impedance is expressed in ohms and refers to the electrical resistance of the sub.
The total opposition to sinusoidal current expressed in ohms.
