Examples of 'pilot holes' in a sentence
Meaning of "pilot holes"
pilot holes: Holes drilled as guides for the proper insertion of screws or nails in woodworking or construction projects. Pilot holes help prevent splitting or damage to the material being drilled into
Show more definitions
- plural of pilot hole
How to use "pilot holes" in a sentence
Basic
Advanced
pilot holes
Drill pilot holes in the mounting surface.
Drill the appropriate size pilot holes.
Drill pilot holes into the window sash.
Remove template and drill pilot holes.
Drill pilot holes for the mounting hardware.
It is positioned by means of two pilot holes.
Drill pilot holes through the side flanges.
You have likely heard of pilot holes before.
Pilot holes are not needed.
Drill three pilot holes along this line.
Screws are self tapping and do not require pilot holes.
It is recommended to drill pilot holes for the trim screws.
Drill pilot holes and attach the sill supports.
Be sure to position the overlay hooks to the pilot holes.
Drill the pilot holes for the header bracket.
See also
Align the hood lower mounting holes with pilot holes in.
Clean clogged pilot holes with a straight pin as shown.
Drill through base into mounting using pilot holes as a guide.
The ability to create pilot holes is enhanced by several features.
Secure screw joint for thin sheets with pilot holes.
Drill pilot holes on the back of the panel at your markings.
Mark the mounting holes and make pilot holes with a bradawl.
Drill pilot holes or insert anchors as needed at the marked locations.
Hold the orifice up to light and verify if both pilot holes are open.
Drill pilot holes into the center of each template mark.
Use the mounting bracket as a template to drill pilot holes in mounting location.
The pilot holes are made anterior to the midbody of the vertebrae.
These divots will serve to mark the pilot holes in the block.
Drill pilot holes into marked positions and into a wall stud.
Place the ledger board in position and line up the pilot holes.
The pilot holes should be slightly smaller than the wood screws in diameter.
Secure through screw holes in cleats drill pilot holes in cleats first if necessary.
Drill pilot holes for larger screws or when driving screws into hardwoods.
Use the four lower holes as a guide to mark and drill pilot holes.
Drill three pilot holes where the holes of the alignment sticker are located.
Center the mounting bracket over the hole and mark pilot holes.
Drill pilot holes in the top panel as you did for the bottom panel.
Inserting such an electrical device without pilot holes risks bending the pins.
Drill pilot holes and attach rails to runner or bottom of cabinet with provided hardware.
This occurs because of the distance increasing between the two pilot holes.
Pilot holes are made for guiding and enabling screw insertion into the vertebra.
The tape will secure the panel in place while drilling the pilot holes.
Drill four pilot holes in the worktable that match the mounting holes of the unit.
Brittle fault zone intersection between the chosen pilot holes were also modelled.
You must drill pilot holes in cabinet to avoid splitting the wood before installing screws.
A drill bit can be fed through the cannula for drilling pilot holes into the mandible.
Drill pilot holes in the chimney support mounting hole locations for your attachment method.
Position the overlay hooks with the pilot holes and push the hooks into the holes.
Predrill pilot holes into the wood rails bordering the doors and top grille panels.
Then I marked and drilled the pilot holes for the carriage bolts.
You'll also be interested in:
Examples of using Pilot
Show more
Pilot projects on payments for ecosystem services
Implementation of pilot projects to develop plant cover
Pilot flew into a mountain in the fog
Examples of using Holes
Show more
Great holes have been cut in the earth
Always remove the lid or put holes in it
They cut holes behind every cabinet
