Examples of 'pipe end' in a sentence
Meaning of "pipe end"
Describes either the termination point or the opening of a pipe, which can be connected to another pipe or a container to facilitate the flow of fluids or substances. The phrase may also refer to the end of a pipe where it is cut, sealed, or joined with other components in plumbing or industrial systems
How to use "pipe end" in a sentence
Basic
Advanced
pipe end
Pipe end with maximum outer diameter.
Device for connecting a pipe end to a member.
Cut the pipe end with a pipe cutter.
Do not reach inside pipe end.
Pipe end not square with pipe axis.
Swagelok tube fitting and pipe end connections.
The pipe end must be evenly flared in a perfect circle.
Method and tool for expanding a pipe end.
Hold the pipe end downwards when removing burrs.
Only retract the cone by pressing against a pipe end.
The pipe end must be evenly fl ared in a perfect circle.
Allow multiple rotations to fully deburr the pipe end.
The pipe end is inserted into one end of an adapter.
This arrangement serves to facilitate disconnecting the pipe end.
Pipe end trimming.
See also
Second axial pipe end.
The smooth pipe end is then inserted into the socket.
The detector or a detector is blown from a suction pipe end.
The pipe end is preferably grooved for mounting with couplings.
This makes it easier for the operator to disconnect the pipe end.
The risks of the pipe end being scratched or moving backwards are then small.
The jaws when retracted are intended to be inserted into the pipe end.
Look at how far the pipe end extends through the ring gage.
The mobile compression ring is pushed further into the pipe end.
The elastomer is vulcanized and allows use at pipe end without using counterflange.
Slowly feed into pipe and press cone against burred pipe end.
Hold the pipe end downwards so that no burrs can fall into the pipe.
A third member is interposed between each pipe end and the bushing.
These pipe end portions are provided with matching threaded portions for their mutual engagement.
The ring can thus contribute to guiding the pipe end in the body.
The second pipe end portion is provided with extensions for engagement with holding tools.
The fins enable more accurate centring of a pipe end received in the coupling.
The receiving station present on the bench consists of an opening connected to a pipe end.
Secondly it is now more easy to keep the pipe end aligned during a pressing action.
The gasket and the locking device lightly enclose the smooth pipe end.
This ensures a joint pressure sufficient to bond the pipe end with the coupling when inserted.
The sequence described above can then be repeated for closing the next pipe end.
Only use clean pipes Hold the pipe end downwards when removing burrs.
For example the way they get to grip an inserted pipe end differs.
To braze the pipe end The indoor unit and outdoor unit have flare connections.
The other planar surface of the seal terminates approximately flush with the pipe end edge.
Insertion of the pipe end into the pipe socket ; and.
The third member melts and a connection is achieved between the pipe end and the bushing.
Each pipe end is to be equipped with a corresponding flushing / drain ball valve.
The pusher 9 serves to disconnect the pipe end.
Finally, the pipe end section still supported by the mandrel is cooled.
This serves to limit radial deformation of the pipe end 1.
In the latter situation, the actual pipe end will inevitably be deformed.
Once pipe end is deburred, pull the tool out of pipe and then.
Electronics box including . connections at upper pipe end of the pylon.
You'll also be interested in:
Examples of using Pipe
Show more
Pressure transmission pipe in the combustion chamber
Pipe is the heaviest wave in the world
Two pieces of pipe and a bicycle chain
Examples of using End
Show more
End poverty in all its forms everywhere
This could be the end of a beautiful friendship
End this before people get hurt
