Examples of 'pipe ends' in a sentence
Meaning of "pipe ends"
pipe ends - the extremities or edges of a pipe. It could also refer to the termination points of a conduit or channel
How to use "pipe ends" in a sentence
Basic
Advanced
pipe ends
A replacement coupling is connected to the pipe ends.
Pipe ends must be cut square.
Fomeco successfully explores robotised deburring of pipe ends.
Both pipe ends remain securely clamped during sawing.
Coupling for connecting pipe ends.
The pipe ends quite simply do not fit together.
Device and method for closing pipe ends.
The fuel pipe ends in a nozzle with a flexible ball joint.
Precision and accuracy are desired when counterboring pipe ends.
It may be necessary to spread the pipe ends apart to install filter assembly.
The thrust forces are maintained during shifting of the pipe ends.
The duct connection and pipe ends shall be sealed during transit.
A crimping tool is used to compress the fitting on the pipe ends.
The duct connection and pipe ends shall remain sealed during transport.
The carriage closes to bring the melted pipe ends together.
See also
This pipe ends just below the supporting drain floor but above the maximum water level.
The pipes are aligned and the two pipe ends are abutting.
Clean the pipe ends and Tee sockets with primer cleaner.
Fluid pressure in a pipeline tends to force the pipe ends apart.
Firstly, the pipe ends must have finished squared ends.
The main following peaks correspond to the reflection on the pipe ends.
The sleeve is applied onto both facing pipe ends by means of a crimping tool.
Stoppers to create the press fit are pressed into the pipe ends.
Secure the 4 pipe ends with a hose clamp not included.
This ensures that no grease or dirt is transferred from hands to pipe ends.
This provides for limited movement of the pipe ends relative to each other.
The resulting laminate generally covers equal amounts of the two abutting pipe ends.
This produces a sealed coupling of the two pipe ends relative to one another.
In that patent the sleeve is shrunk into frictional engagement with two pipe ends.
Thoroughly clean out the plugs or caps and pipe ends with cleaning solution.
The liners are electrically coupled through a conductive ring situated between the pipe ends.
In some reformers, the riser pipe ends with a gas distributor.
For large pipes, api welding bevel on both pipe ends.
For this purpose, the pipe ends are held on the base plates by a press fit.
Many different clamping straps as well as methods for joining pipe ends are known.
After insertion, the pipe ends are sealed and water pressure is applied to the inliner.
An internal stop at the centre of the fitting prevents the pipe ends from meeting.
Seal all pipe ends hermetically with a suitable plug, pending the installation of the cable.
The coil sections are arranged for cooperation with respective pipe ends in well known manner.
A method of joining two pipe ends without rotating said pipe ends comprising the steps of,.
The main bodies can be pulled together, pulling the pipe ends together.
The two pipe ends are arranged in end-to-end relationship.
Figure 1 is a schematic representation showing the general disposition of pipe ends requiring connection ;.
Equipment for different forming of pipe ends welding, tube forming, flaring tube 37 and cutting ring.
Instead, a single piping joint may be fitted only on either of the open pipe ends.
Once the pipe ends make contact, the microprocessor 440 begins counting down for fuse cycle.
Figure 3 shows the longitudinal and cross sections of the coupler before joining the pipe ends.
The pipe ends could also be slightly spaced, again as shown in Fig . 6.
When de-installing these known devices, an operator manually unscrews the devices from the pipe ends.
It is only possible when the pipe ends are open . You can do a Macro-test.
You'll also be interested in:
Examples of using Pipe
Show more
Pressure transmission pipe in the combustion chamber
Pipe is the heaviest wave in the world
Two pieces of pipe and a bicycle chain
Examples of using Ends
Show more
Take the ends of the hair fig
Ends designed to facilitate continuous row mounting
Check that both ends are correctly plugged in
