Examples of 'pipe size' in a sentence
Meaning of "pipe size"
pipe size: This phrase refers to the diameter measurement of a pipe, typically used in plumbing or construction to specify the appropriate fittings and fixtures
How to use "pipe size" in a sentence
Basic
Advanced
pipe size
Same to connecting pipe size of outdoor unit.
Pipe size between branching sections.
Do not increase pipe size by stages.
Select the thickness of insulating material by pipe size.
Based on pipe size pipes other than steel.
Use the fl are nuts for the following pipe size.
Minimum pipe size for compressed air line.
Position pipe stand rollers for pipe size being used.
Refrigerant pipe size and allowable pipe length.
Sizes are specified using the nominal pipe size system.
Increase pipe size on long runs.
The range includes a clamp for each common pipe size.
Connecting pipe size of indoor unit.
Pipe size for connecting piping between outdoor units.
The smaller pipe size.
See also
Select the pipe size nearest to the required size.
Change the definition of the pipe size for a large.
Sketches of the pipe size and location will have been done.
Use the flare nuts for the following pipe size.
The pipe size must be at least as large as the discharge port.
Which are commonly used to change the pipe size or pressure in a piping system.
The pipe size is smaller than the suggested pipe size.
Pipe support stand rollers not in correct location for pipe size.
Nominal pipe size not greater than nominal device size.
More expensive at smaller sizes starts to even out as pipe size increases.
Nominal pipe size outside diameter back to face center to center.
One set of dies is required for each of the following pipe size ranges.
The pipe size depends not only on the volume of air.
Use correct flare nuts meeting the pipe size of the outdoor unit.
The correct pipe size is installed and the pipes are properly insulated.
The pipe wall thickness variation was within the tolerance for the pipe size.
Not using the standard pipe size may result in capacity decrease.
Pipe size differs based on total capacity code value of indoor units at downstream side.
Do not reduce the discharge pipe size below that which is provided on the pump.
This higher pressure allows for a much longer distance and in a much smaller pipe size.
Minimum pipe size must be maintained for the total length of exhaust pipe.
Brass and copper fittings and valves typically have smaller bores than the associated pipe size.
The minimum pipe size must be maintained for the total length of the inlet pipe.
Pipework reducers Always avoid extreme step changes in pipe size.
Standard liquid pipe size Connected piping length is between.
Check this System Pipe Length to see if it exceeds the minimum pipe size.
Size up liquid pipe size Connected piping length is between.
Piping parts Name Selection of pipe size.
Connecting pipe size of indoor unit Indoor unit capacity type Gas pipe Liquid pipe.
At steady speeds mouth pipe size what should we use?
It is proportional to flow rate, but does not depend on pipe size.
In this application, the pipe size must be determined using two factors.
For improved pool plumbing, it is recommended to use a larger pipe size.
Pipe size Number of rolls / size required.
To determine the complete recharge amount (kg) in case of standard liquid pipe size.
You'll also be interested in:
Examples of using Size
Show more
Change duct size gradually to minimize turbulence
I do not want a comedian knowing my dress size
Size expressed as minimum and maximum weight
Examples of using Pipe
Show more
Pressure transmission pipe in the combustion chamber
Pipe is the heaviest wave in the world
Two pieces of pipe and a bicycle chain
