Examples of 'piping must' in a sentence
Meaning of "piping must"
The phrase 'piping must' suggests that there is a requirement or obligation related to the installation, maintenance, or use of pipes or a piping system. It implies that certain actions, standards, or regulations must be followed or adhered to in relation to the piping
How to use "piping must" in a sentence
Basic
Advanced
piping must
All piping must be of a suitable metallic material.
The connection piping must be insulated.
Piping must be of the correct size to maintain the.
During the installation the piping must not create undesired siphons.
Piping must comply with the criteria below.
Any horizontal run of suction piping must have a gradual upslope towards the pump.
Piping must be constructed of steel and cathodically protected.
Minimum floor area for installation Refrigerant piping must be protected from physical damage.
Refrigerant piping must be protected from physical damage.
The lining of the tank, tank fittings and piping must be.
All piping must be fully supported.
All connections to the gas piping must be wrench-tightened.
Copper piping must not be used in the system.
Filtering, the gas flowing in the piping must be adequately filtered.
All piping must be removed as well.
See also
To protect the actuator from excessive heat, the piping must be insulated.
The outside piping must be tilted downward to drain.
A valid inspection certificate for the loading / unloading piping must be available on board.
The piping must be insulated metal.
Additionally, openings for wiring and piping must be machined on cross member end plates.
Piping must be clean and free from scale or burr.
The minimal pipe thickness for R410A piping must be in accordance with the table below.
Piping must be clean and free from scale or burrs.
Thermal resistance of the insulation for gas piping must be 120 C or higher.
The internal piping must extend to the tower exterior.
Piping must be accurately designed according to the nominal performances of the machine.
The discharge piping must be at least as large as the tank tee.
Piping must be supported at intervals along the length in accordance with local codes.
Insulation of field piping must be carried out up to the connection inside the casing.
Piping must conform to local / country plumbing and sanitary codes.
The plant layout and piping must allow complete draining of all circuits.
All piping must be properly sized for expected flow rates.
The grain piping must be supported by its first joint.
All piping must conform to local and state plumbing and sanitary codes.
The transmitter and piping must be in good contact and well grounded during installation.
Piping must conform to local / state plumbing and sanitary codes.
All field gas piping must be pressure / leak tested prior to.
All this piping must go down into a tunnel or a shaft or something.
Underground piping must have a minimum of 18 " cover.
Suction piping must slope upwards to the pump on any horizontal pipe sections.
In any case, piping must not be smaller than pump discharge.
All gas piping must be installed in compliance with local codes and utility regulations.
The whole gas piping must be checked carefully for leakages with a leak indicator spray.
The piping must include breakage grooves and suitable bracing ;.
A tank and its piping must be protected against external corrosion by paint, cover or coating.
IMPORTANT, Piping must yield slightly to allow the gaskets to crush and seal completely.
All this piping must go down into a tunnel or a shaft or something, yes?
All this piping must go down into a tunnel or a shaft or something, yes? With us?
Well, this piping must go down into a tunnel or a shaft, or something, yes?
All piping must be insulated in accordance with applicable standards in Italy law 10/91.
