Examples of 'polymer samples' in a sentence
Meaning of "polymer samples"
polymer samples: Polymer samples refer to small amounts of polymers that are used for testing, analysis, or research purposes in fields such as chemistry, materials science, and engineering
How to use "polymer samples" in a sentence
Basic
Advanced
polymer samples
The polymer samples were suspended in the solution.
They can be utilized to identify polymer samples.
Polymer samples were thoroughly dried prior to testing.
Gel chromatography against polystyrene standards of polymer samples of films a.
Polymer samples were prepared as described above.
The measurements were obtained by dissolving polymer samples in hot trichlorobenzene and filtered.
The polymer samples were collected in receptacles below the outlet valve.
Using this method resulted in polymer samples with undesirable release kinetics.
Polymer samples were collected and analyzed after three bed turnovers.
The percentage of polypropylene macromer in the polymer samples was calculated by mass balance.
The polymer samples were also subjected to gravitational cold flow measurements.
Several fiber samples were analyzed in the same way as the polymer samples.
The polymer samples were dried under vacuum prior to the measurements.
They will also have the opportunity to produce their own polymer samples.
The polymer samples are removed from the molds after cooling.
See also
QUV is an accelerated weathering tester in which polymer samples are exposed under UV light.
All polymer samples used in the examples have atactic stereostructure.
Leather coated with coatings containing all polymer Samples except Comp.
The polymer samples were made by reacting terephthaloyl dichloride in solution with the diol monomers.
Preparation of the Examples Polymer samples.
Polymer samples were dissolved in methylene chloride and films were cast directly onto NaCl plates.
Figure 2 illustrates seal strength of polymer samples.
Treated polymer samples with corresponding additive and water percentages used in the process.
Figure 5 illustrates hot tack curves of polymer samples.
Serial analysis of the polymer samples using two switched loops and overlapping injections are used.
Figure 4 illustrates seal initiation curves of polymer samples.
Polymer samples are collected after several bed turnovers once the reactor and product are stabilized.
To evaluate their effectiveness, polymer samples were analyzed in the following test.
The polymer samples were then recovered from the polymer cements and evaluated to determine stability.
Table 3 illustrates the properties of the polymer samples further analyzed.
The obtained polymer samples and vinyl chloride resin compositions prepared using them were estimated.
The resulting ' wet cake ' was fluid bed dried before polymer samples were analysed.
The polymer samples taken from the reactor during two hours exhibited significant static electricity.
According to the present invention, the polymer samples are analysed by gas chromatographic pyrolysis.
The polymer samples are fractionated in a Kumagawa apparatus.
All-points histograms of the ionic current reflect the distinct natures of the two polymer samples.
Polymer samples were packaged in storage bags and labeled with appropriate information Example.
Figure 3 illustrates a DSC trace of polymer samples.
Comparative polymer samples were also prepared in which PGPR was replaced by a commercial dispersing agent.
The experimental conditions and viscosity of polymer samples are presented in Table 15.
Polymer samples were measured into 8 mL glass vials.
The Mooney viscosity of each of the recovered polymer samples is displayed in Table 5.
The glucose polymer samples are prepared according to example 1.
The polymerisation data and properties of the polymer samples are reported in Table 1.
Eight polymer samples were tested together ; these are described below.
After at least three bed turnovers polymer samples were collected and analyzed . Table 2.
Particle size / Particle size distribution A gradation test was performed on the polymer samples.
For analysis, the polymer samples were first dissolved in deuterated chloroform.
FIG . 2 illustrates seal strength of polymer samples.
Example 2 Polymer samples were prepared as described above.
You'll also be interested in:
Examples of using Polymer
Show more
Injected polymer compound shell in three sizes
We seem to be a bit light in the polymer sciences
High resistance polymer flow indicator cover
Examples of using Samples
Show more
I brought back samples of her root that
Samples should be related to the proposed project
Please take my samples back with you
