Examples of 'regeneration phase' in a sentence
Meaning of "regeneration phase"
Regeneration phase: A stage in a process or project where renewal, growth, or restoration is taking place to improve or revitalize something
How to use "regeneration phase" in a sentence
Basic
Advanced
regeneration phase
A regeneration phase is then carried out.
During regeneration the active regeneration phase is displayed.
A regeneration phase then occurs.
Shortens the regeneration phase.
An addressing cycle is composed of an emission phase and a regeneration phase.
After this regeneration phase aliquots were plated on selection plates.
Helps your skin to maximize its natural regeneration phase.
The regeneration phase works on the principle of inverse ionic exchange.
The anode does not attract electrons during a regeneration phase.
Regeneration phase completed.
In the choice of the threshold at which a regeneration phase is initiated or stopped.
The regeneration phase is idle time as far as use of the source is concerned.
The possibility is thus available of operating in the adsorption or the regeneration phase.
Short regeneration phase.
The pressure vessel was drained of unfiltered suspension prior to the regeneration phase.
See also
In case of a following regeneration phase the counting device will run in minutes again.
It shall not be permitted during the measurement of emissions during the regeneration phase.
After the last regeneration phase the control will return to the service position.
The gas mixture traverses the reactor where the catalyst is in its regeneration phase.
Phase C is the rapid regeneration phase of the device.
The activated “ fast regeneration ” only applies to the actual regeneration phase.
At point in time t 1, the first regeneration phase ends and a first measuring phase follows.
The auxiliary adsorber 6 is in the regeneration phase.
This used catalyst regeneration phase was identical in every respect to that described in Example 1.
A notable improvement in the NO x trap regeneration phase is thus obtained.
This regeneration phase employs the reactor R3.
Stage 2 is the repair and regeneration phase.
Passive regeneration phase ( recovery phase ).
In each case, the switch on point is the start of a new regeneration phase.
Regeneration phase with,.
Beyond a predetermined value of this loss of pressure, a regeneration phase is carried out.
However, this important regeneration phase only kicks in after 16 hours of fasting.
Additionally, these methods imply a considerable energy loss especially in the regeneration phase.
During the regeneration phase 51 in a first part heater 3b heats volume 3a that will emit steam.
Furthermore, the manifolding allows for the isolation of a bed during the regeneration phase.
Finally, the regeneration phase comprises,.
How long does the preparation last for a fight? How long is the regeneration phase afterwards?
During the regeneration phase of the cycles, the average CuO bed regeneration was > 90 %.
The “ high-speed ” that is switched on exclusively applies to the current regeneration phase.
Moreover, the adsorber 5 A is in the regeneration phase.
The adsorbed solvents and / or VOCs are recovered as liquids, during the unit 's regeneration phase.
The adsorber 11 or 12 which is not in the production phase is in the regeneration phase.
You'll also be interested in:
Examples of using Phase
Show more
The first phase evolved over millennia
Review of the execution of the design phase
The results of phase two have been amazing
Examples of using Regeneration
Show more
Set days and time of regeneration or recharge
Regeneration levels can be controlled in a similar way
England integrated regeneration and social policies
