Examples of 'retighten' in a sentence
Meaning of "retighten"
retighten (verb): The action of tightening something, such as a bolt, screw, or fastener, again after it has become loose or to ensure it is securely in place
Show more definitions
- to tighten again
How to use "retighten" in a sentence
Basic
Advanced
retighten
Retighten cylinder and repeat soapy solution.
Reposition and retighten to desired depth location.
Retighten the cap to the filter housing.
Replace and retighten the six screws.
Retighten mounting screws on any loose part.
Lower the bevel adjustment lever to retighten.
Retighten the handgrip in the new position.
Periodically check screws and retighten as necessary.
Gently retighten the lens lock screw.
Adjust mounting plate and retighten screws.
Retighten screws on both backrest pivot plates.
Turn the bevel adjustment knob to retighten.
Retighten the drain plug when completed.
Then carefully retighten the screw.
Retighten the rip scale indicator screws.
See also
Do not forget to retighten the ring clamps afterward.
Retighten the rip scale pointer screws.
Check all screwed connections and retighten if necessary.
Retighten any loose bolts and nuts.
Check bolts and nuts and retighten if necessary.
Retighten screws after the commissioning procedure.
Deploy the table extension and retighten both.
Retighten the screw after adjustment is complete.
Replace oil dipstick and retighten.
Always retighten loose screws and nuts.
Calibrate knob and retighten screw.
Retighten any vent clamps that are loosened.
After setting the position retighten the screws.
Retighten the screws in their initial position.
Depth adjustment knob and then retighten securely.
Retighten the depth adjustment lever securely.
Remove trap lid and retighten hand tight only.
Retighten the hex bolts when finished.
Slide the trim up or down to adjust and retighten screws.
Retighten the drop foot lock knob.
Drain the system completely and retighten the plug.
Retighten the motor drive pulley setscrew.
Insert a new power supply and retighten the screw.
Retighten the zoom and focus pullers.
Close the cylinder valve then retighten all connections.
Retighten the bevel adjust lever or knob.
Check all the engine screws and retighten them.
Retighten the screw of the dynamo bracket.
It might be necessary to loosen and then to retighten the screws.
Retighten the bolt of the dynamo bracket.
Check tightness after initial use and retighten if needed.
Also retighten this connection with pliers.
Periodically check for looseness of screws or nuts and retighten.
And retighten it with the currently removed.
Close the lamp housing and retighten the screws.
