Examples of 'screw heads' in a sentence
Meaning of "screw heads"
screw heads ~ refers to the metallic protruding part of a screw that is used to fasten objects together. This phrase can also be used metaphorically to describe people who are difficult, stubborn, or troublesome to deal with
Show more definitions
- plural of screw head
How to use "screw heads" in a sentence
Basic
Advanced
screw heads
Machining of ball and trapezoidal screw heads.
Screw heads must be countersunk into the panel.
Remove nail and screw heads before scraping.
Screw heads should be recessed below the surface.
Someone stripped the screw heads.
Screw heads or bits will be damaged unless a bit.
The paint still covers the screw heads.
Screw heads must be flush with back of custom panel.
Making of formats and screw heads.
Adjust height of screw heads to securely lock monitor in place.
Place the supplied plastic caps on the screw heads.
There must be no screw heads on the exterior of the door.
Hang the telephone on the slightly protruding screw heads.
Apply additional sealant to the screw heads and bracket to ensure a.
Fully usable front panel area with no intrusive screw heads.
See also
Rotate clockwise until screw heads fully engage into keyholes.
Replace the covering caps over the screw heads.
Be sure the screw heads are in the narrow neck of the keyhole slot.
The screws should be installed so that the screw heads are.
Screw heads may or may not contact speaker bracket when tight.
Different screw heads.
Look through the clock window to locate the screw heads.
The lamp toppled and the screw heads were torn out.
Cheap tools tend to overturn and damages the screw heads.
Lay unit on a flat table with screw heads in housing facing upwards.
Use only screwdriver bits that fit the screw heads.
Be sure all screw heads are positioned in the matching countersunk slots in shoe.
Seal all around the mounting screw heads with caulk.
Screw heads may need to be countersunk into the panel for proper alignment.
Do not tighten too strongly as the screw heads will be damaged.
Put caps on the screw heads on the right and left side panels.
Place spring washers beneath all screw heads and nuts.
Ensure that the screw heads do not come in contact with magnetic seal.
Lift fi xture housing to ceiling inserting screw heads into keyhole slots.
Ensure that the screw heads are flush with or recessed below the bracket surface.
Around the base and on top of the screw heads after installation.
The tether was sequentially placed into all of the additional screw heads.
Then seal the joint and screw heads with high temperature sealant.
This also applies for all driving means such as screw heads.
Push light kit assembly up to engage screw heads in slots and turn to secure.
Check to make sure that the device is correctly positioned on both screw heads.
Place the key holes over the screw heads and push the mi.
This type of clamping is very strong and allows stamping operations on screw heads.
Mount the SurgeArrest over the screw heads and slide down into place.
Place the keyhole slots in the mounting brackets over the screw heads.
Place the scales onto the screw heads using the mounting e intended for this purpose.
Start at a low operating torque to avoid tightfitting screw heads from twisting off.
Screw heads Right side of the oven wall.
Use the screw collars supplied to prevent damage caused by the screw heads.
Slide the assembled side shelf over the screw heads and finish tightening.
You'll also be interested in:
Examples of using Heads
Show more
I can not make heads or tails of reality
Heads of bolts go on the inside of the cart
To cut off the heads of those flowers
Examples of using Screw
Show more
Tighten the screw through the clips
Screw the two sections of pole together
Remove the screw on the rear coupler
