Examples of 'screws that hold' in a sentence
Meaning of "screws that hold"
Symbolically refers to the essential or fundamental components, factors, or elements that support or hold together a specific structure, system, or concept
How to use "screws that hold" in a sentence
Basic
Advanced
screws that hold
Only as strong as the screws that hold it in.
Phillips screws that hold connection box to heater.
Of a screwdriver to manipulate the screws that hold the piece.
Screws that hold the door hinge on the.
Location of five screws that hold electronics assembly.
This can clearly be seen on the two screws that hold the.
The set screws that hold it on were lose.
Remove the hinge cover and screws that hold the.
Refit the screws that hold the rear in position.
Remove the top grille by removing the two screws that hold it in place.
Remove the screws that hold each dual burner.
Remove the top grill by removing the two screws that hold it in place.
Remove four screws that hold circuit breaker cover to air.
Remove bottom bezel and the two screws that hold the grille.
Remove two screws that hold upper coin chute cover.
See also
Take a Phillips screwdriver and unscrew all the screws that hold the kitchen trap in place.
Loosen the screws that hold the water pump in place.
Now we'll put the two screws that hold the.
Loosen the screws that hold the starter against the.
Remove the top grille by removing the 3 screws that hold it in place.
Remove screws that hold lamp guard and reflector in place.
Then remove the three screws that hold the hinge.
All the screws that hold the console together have been lost.
Behind the frame are the two screws that hold the panel in place.
Loosen the screws that hold the starter against the crankcase and remove the starter.
Adjust the chain by loosening the two screws that hold the tilting bearing.
Loosen the screws that hold the combo drive bracket in place.
Remove the headshell from thd tonearm, and the screws that hold the cartridge.
Remove the four screws that hold the circulation pump.
Remove the three M5 sheet metal screws that hold.
There are two screws that hold the sensor.
Screws that hold the main burner / pilot.
Remove the five screws that hold the cover.
There are 2 screws that hold the disc drawer securely in place during shipment.
Open the small door and unscrew the screws that hold the thermostat to the wall.
Remove the screws that hold the lens covers 2 screws typ . for top and bottom.
Using a small screwdriver, remove the four screws that hold the back plate into position.
Unscrew the 2 screws that hold the cover with the lenses & gently remove the cover.
Using a Phillips screwdriver, remove the screws that hold each handle in place.
Remove the screws that hold the top hinge to the cabinet.
To do this, simply unscrew the 3 screws that hold the profiles.
Check that the screws that hold the blades together are correctly tightened.
Do not attempt to remove the 2 “ tamper-resistant ” screws that hold the inner glass in place.
The pins and screws that hold the mechanism together are made of steel.
To replace the fuse, carefully release the 4 screws that hold the PCB ; these.
Inspect the screws that hold down the top rails.
From the front remove the six ( 6 ) screws that hold the.
Remove the two screws that hold the disk in place.
Remove the protective cover Q ( Fig . 4 ) by loosening the 2 screws that hold it in place.
Remove the three screws that hold the plates on the.
You'll also be interested in:
Examples of using Screws
Show more
The screws are provided in the literature pack
Fully tighten screws with hex wrench
Screws are visible on the burner control panel
Examples of using Hold
Show more
Frank might not hold kindly to that
Hold the equipment fi rmly by the handle
The way you hold your head
