Examples of 'setscrew' in a sentence
Meaning of "setscrew"
setscrew (noun): A type of screw that is used to secure an object within or against another object, often used in machinery or manufacturing processes
Show more definitions
- Alternative spelling of set screw
How to use "setscrew" in a sentence
Basic
Advanced
setscrew
Loosen the setscrew on the motor pulley.
Retighten the motor drive pulley setscrew.
Loose setscrew could create fan wobble.
Adjust as required using setscrew on propeller hub.
Setscrew and nut in downrod support is loose.
Overtightening of setscrew can damage threads on pipe.
Secure the axle by tightening the setscrew.
Loosen the setscrew on the engine pulley.
Secure the handle in place with the setscrew.
Loosen the setscrew with the screwdriver.
Retighten the engine pulley setscrew.
Loosen setscrew located on rear face of machine.
Do not remove this setscrew completely.
Other setscrew located on opposite side.
It is advised to replace the setscrew from time to time.
See also
Setscrew for the focus adjustment at the lens.
Remove the cap and setscrew on the faceplate.
Setscrew wrench for nozzle disassembly.
Then tighten the setscrew to lock the ring.
Setscrew will not be recessed into the handle.
Never fasten the setscrew when no knife is inserted.
Then secure the knife with the setscrew.
Tighten the setscrew by turning it clockwise.
Place a small drop of threadlock on each wheel collar setscrew.
Loosen the setscrew and remove the attachment.
Use a fl at fi le to make an area where the setscrew will tighten.
Loosen the setscrew of the desired needle position.
These elements are a hybrid between an articulation bolt and a setscrew.
Tighten the setscrew in the collar.
Push the needle up as far as it will go and tighten the setscrew securely.
Tighten the setscrew on the fl at area of the axle.
Align the lower portion of the handle and fasten it with the setscrew.
There is a small setscrew to hold it in place.
The setscrew is tightened until it bears against the side of the connector pin.
Start by loosening the setscrew in the center of the actuator.
Insert the short end of the hex key into the setscrew and.
Loosen the setscrew on the lower knife retaining plate.
Reassemble plug element into microphone and seal setscrew securely by turning out clockwise.
Remove the setscrew from the lower part of the handle.
Press the escutcheon against the finished wall and secure with the setscrew.
Loosen the setscrew and remove the installed pinion gear.
The restraint arm is configured to capture the existing setscrew located in the restrainer bracket.
Tighten the setscrew when you reach the desired depth.
Slide the insulated handle onto the electrode holder and tighten the handle setscrew.
Lightly tighten the setscrew to prevent it from loosening during sewing.
Make sure that the composite plastic pad is in the proper position under the setscrew.
When accomplished tighten the setscrew in the center of the actuator.
Turn setscrew with hex key and adjust base until it is.
Raise the presser bar and turn the setscrew counterclockwise to remove it.
Ensure the setscrew contacts the fl at area machined into the tail shaft.
