Examples of 'shaft should' in a sentence
Meaning of "shaft should"
This phrase suggests that a shaft or a long, narrow part of an object should be in a certain condition or have a specific characteristic. It implies an expectation or requirement related to the state or quality of the shaft
How to use "shaft should" in a sentence
Basic
Advanced
shaft should
The shaft should turn freely if unobstructed.
The central wiring shaft should be up ahead.
The shaft should pierce armor.
But the elevator shaft should be solid.
Club shaft should be parallel to the target line.
The flat side of the shaft should be exactly.
The shaft should be totally clean before moving on.
This distal end of a pole shaft should be interpreted broadly.
This shaft should take us back to where we came from.
Both the kneader and driving shaft should be cleaned.
The damper shaft should be lubricated when neccesary.
At this point the U joint at either end of the shaft should be checked.
Our second shaft should be just beyond there.
Once per season, the wedge on the drive shaft should be greased.
The probe shaft should be marked accordingly at the position.
See also
It is however recommended that a second shaft should also be a motor-driven shaft.
Pump shaft should be completely dry before moving on to the next step.
The flat side of the shaft should be towards the back.
The shaft should not move more than 2 mm if the bleed was successful.
The kneader and the drive shaft should be cleaned immediately after use.
The shaft should not be too flexible ; it should be straight and easy to handle.
Both the kneader and driving shaft should be cleaned immediately after use.
The shaft should always be held at an angle of 60 or less.
In case of a hollow shaft with key way, the shaft should also be replaced.
The rotisserie shaft should rotate so that the heavy side of the meat or poultry.
During turning or reversing, articulated telescopic shaft should be disengaged and windrower raised.
A catheter shaft should have adequate strength for pushability and resistance to buckling or kinking.
If they ventilated down this far, the air shaft should be behind this wall.
The chisel shaft should be lubricated with a little normal lubricating grease from time to time.
The stairwell and the elevator shaft should not have three, but four layers.
The tail shaft should extend out of the left side plate bearing by approximately 1mm.
During turning or reversing, PTO shaft should be disengaged and tedder raised.
Drive shaft should be greased every 50 hours of operation.
And if my calculations are correct … Our second shaft should be just beyond there.
The top end of the shaft should protrude through the hole in the lid.
Generally, at least about 40 percent of each shaft should be covered with mixing paddles.
The shaft should pierce armor . - Yes.
The diameter of the shaft should be ø11 mm.
The groove in the shaft should line up exactly with the presser foot pin D.
The drive shaft end in the lower shaft should be lubricated with grease every 30 hours.
This flexible drive shaft should be regularly lubricated every 25 hours in operation.
The inner rotary shaft should be inserted into the collet.
Revolution speed of PTO shaft should be reduced when a drier swath is raked.
In that case, that one shaft should actually be drivable as well as detachable.
The seals around the motor shaft should be lubricated regularly using a food-safe lubricant.
The propeller shaft should have a diameter of at least 25 mm.
You'll also be interested in:
Examples of using Shaft
Show more
This is the shaft of the pry bar
Shaft seal depends on water for lubrication
Blind hollow shaft or hollow through shaft
