Examples of 'sheet thickness' in a sentence
Meaning of "sheet thickness"
The measure of the thickness or width of a sheet, usually referring to materials like paper, metal, or fabric
How to use "sheet thickness" in a sentence
Basic
Advanced
sheet thickness
The sheet thickness is independent of changes in gain.
Drying time depends of sheet thickness.
Dimensions the sheet thickness of the profiled sheet.
Homogenization of the hydrogen distribution through the sheet thickness.
Where e is the sheet thickness in millimetres.
Sheet thickness can be regulated by screw and processing roller.
Suitable sheet thickness.
The sheet thickness is the result of this digital subtraction.
We recommend that the smallest radius be double the sheet thickness.
Combination of a sheet thickness is also not particularly limited.
This slab is progressively reduced to a coil of the required sheet thickness.
Foamed sheet thickness is important.
The length of the temperature cycle depends on the sheet thickness.
Decreasing sheet thickness by half reduces longevity by about half.
In some cases bending may produce a small change in sheet thickness.
See also
Outer sheet thickness mm.
The rolled sheet is then removed in the desired sheet thickness.
Top sheet thickness.
Residence time and temperature rates are related to final sheet thickness.
Even sheet thickness.
Inner diameter d of a hole was measured when a crack penetrated through a sheet thickness.
Single sheet thickness.
Sheet thickness measurement system for easy and reliable measurement results.
The cutting depth is reported as the percentage of the total sheet thickness.
Paper sheet thickness detecting sensor and banknote classifying unit.
The gaps between them are precisely adjusted to the desired sheet thickness.
It is easy to process a sheet thickness given in numerical form by computer digital techniques.
In the preferred form of the invention optical type sheet thickness sensors are used.
The paper sheet thickness can reach the thickness of bible paper.
P tends to segregate at the middle of steel sheet thickness and causes weld embrittlement.
Above sheet thickness and sizes vary according to the perforated mesh sizes.
A typical example of such a sheet handling device is a sheet thickness monitoring or detection device.
This variation in sheet thickness results in large differences in the observed absorption rates.
Calendering is a high speed operation designed to reduce sheet thickness and improve surface smoothness.
Sheet thickness will vary depending on the material and the intended use.
This phenomenon is called sagging and affects the uniformity of the sheet thickness distribution.
This prevents the sheet thickness of the side wall part from decreasing.
BECO depth filter sheet with a reduced sheet thickness.
Plies per sheet Thickness in mm of.
In the table R represents the bending radius and t the sheet thickness.
For correct cover measurements the sheet thickness must be set as Cover Offset value.
The sheet thickness of all test bodies was 1 mm.
However, it is to be understood that this time is dependent on sheet thickness.
Db ath blec schnitt blech Sheet thickness Defines the thickness of the sheet metal.
However, the net effect is still a dramatic increase in effective sheet thickness.
The sheet thickness has been reduced to about 3 mm.
In preferred hollow-fiber sheets, the sheet thickness is as thick as one hollow fiber.
Some sheet thickness is lost however, which is undesirable.
During this process, overlaps, tolerances and sheet thickness values can be determined.
Moreover, the sheet thickness is observed as being more homogeneous.
You'll also be interested in:
Examples of using Thickness
Show more
Minimum recommended thickness of zinc vs thickness of steel
Thickness of tanks made with double walls
Reduction of wall thickness and additional protection
Examples of using Sheet
Show more
Polycarbonate sheet to protect against direct contacts
We got all type of potential on this sheet
Model information sheet for local communities
