Examples of 'starter cable' in a sentence
Meaning of "starter cable"
A starter cable, also known as jumper cables, is a pair of insulated cables with clamps used to jump-start a vehicle by connecting its dead battery to the charged battery of another vehicle
How to use "starter cable" in a sentence
Basic
Advanced
starter cable
Then tug sharply on the starter cable.
Pull the starter cable several times to clean.
Start the engine by forcefully pulling out the starter cable.
Pull the starter cable hard.
The unit has been deliberately shipped with the starter cable disconnected.
Pull the starter cable grip briskly outwards to.
Remove the rear screw that attaches the jump starter cable to the jaw.
Unspool the starter cable from the drum only.
Always remove the spark plug connector before fitting the bar and the starter cable holder.
This prevents the starter cable popping out.
Guide starter cable back by hand to the reset position.
Then tug sharply on the starter cable 4 times.
Hold the starter cable handle firmly when starting.
For efficient starting, it is important to pull the starter cable quickly and powerfully.
Do not let the starter cable bounce back risk of damage.
See also
And hold tight Z - Slowly pull the starter cable.
Always pull the starter cable out in a straight line.
Starter cable at engine not fi rmly connected Check connection.
Never wind the starter cable around your hand.
Pull the starter cable several times carefully to wet the internal components with the oil.
Important, Never allow the starter cable to snap back.
Pull the starter cable out a short way until you.
Keep pulling the starter cable until the engine catches.
Pull the starter cable strong and rapidly until you hear the first audible ignition.
Remote starter cable.
Put starter cable onto post and re-install washer and nut.
Do not allow the starter cable to whip back of its own accord.
Attach the starter cable leads shown in figure 8 to the battery.
Slowly pull out the starter cable until you notice a resi.
Locate starter cable a hang tag is attached as shown in Figure 3.
When you pull out the starter cable hold the starter handle firmly.
Pull the starter cable again, quickly and firmly.
Quickly pull out the starter cable and then let it slowly wind up again.
Wind on the starter cable as described above under “ Replacing the starter cable ”.
Always hold the starter cable when the starter line retracts.
Pull out the starter cable ( 3 ) and fit in the starter handle mount ( 4 ) with a twist motion.
Always remove the starter cable from your Kraftprotz.
Unhook the starter cable from the hook Fig . 3c.
Pull out quickly starter cable and afterwards, let it slowly wind up!
Wind on the starter cable see above under “ Replacing the starter cable ”.
You'll also be interested in:
Examples of using Starter
Show more
Starter fluid or firelighters should not be used
Then pull recoil starter briskly again
Oem starter rebuild kits for atv
Examples of using Cable
Show more
Secure the coaxial cable to the ceiling
A cable tie is provided with the appliance
Use plenum rated cable where it is required
