Examples of 'stop screw' in a sentence
Meaning of "stop screw"
Stop screw is an instruction or command to cease or halt an activity or behavior that is causing problems or complications. It is often used as a direct command to someone
How to use "stop screw" in a sentence
Basic
Advanced
stop screw
Replace door stop screw and tighten.
Tighten the cover plate stop screw.
Adjust the stop screw on left side.
Replace locking plate and door stop screw.
Adjust the stop screw on right side.
Check for proper installation of the stop screw.
Tighten cable stop screw to secure cable.
Loosen the locknut on the downward travel stop screw.
Drive the stop screw in close to the frame.
Set aside door stop screw.
Locate the stop screw in the hardware bag.
Hold the guide wheels and screw in the stop screw.
Then release the stop screw of the limiter.
Tighten the locking nut while holding the stop screw.
Replace door stop screw in bottom hinge and tighten screw.
See also
Locate the bottom hinge and remove the door stop screw.
The depth stop screw allows the depth of cut to be adjusted.
Slide the lower duct cover up and above the stop screw.
Replace the door stop screw or screws in the bottom hinge.
Check the play between the lever arm and the stop screw.
Loosen the focus stop screw on left hand side of microscope.
Move the arm to the left until it stops on the left bevel stop screw.
Adjusting the throttle stop screw idle speed adjustment screw.
Insert the camera into the ball joint and fasten with the stop screw.
Screw throttle stop screw in until it contacts the throttle arm.
Make sure the throttle lever is touching the stop screw before measuring rpm.
Adjust limit stop screw until it touches the saw housing.
Tighten the Tilt Up limit stop screw.
Remove the door stop screw from the bottom side of the.
Tighten the Tilt Down limit stop screw.
Turn the throttle stop screw to obtain the standard idle speed.
Insert the camera into the bracket, and fasten with the stop screw.
Hold the stop screw in place and tighten the lock nut.
Slotted screwdriver for the throttle stop screw and the main jet needle Aids.
Back throttle stop screw out enough to allow throttle to be adjusted to full throttle.
If doors open too wide, remove door stop screw from bottom door hinge.
Remove the stop screw that limits rotation of the forward section of the saw arm.
If door opens too wide, remove door stop screw from bottom door hinge.
Remove door stop screw from the bottom door hinge using the Allen wrench.
For minor adjustments, simply rotate the depth stop screw to the desired location.
Replace the door stop screw or screws in the bottom hinge and tighten.
For adjustment of groove depth, pull out depth stop plate and rotate depth stop screw.
Replace the door stop screw in the bottom hinge and tighten the screw.
If the door opens too wide, remove the door stop screw from the bottom hinge.
Stop screw loosely in the hole, and then.
This will allow the depth stop screw to pass through the hole in the plate.
Stop screw for limiting movement. This stopper is primarily intended for Afag actuators, but a ha.
Adjust the left side bevel stop screw upwards until it firmly touches the bevel stop.
The slidable jaw 8 is prevented from falling out by a stop screw 15.
Normal screwdriver for the throttle stop screw and the main nozzle needle Auxiliary materials.
