Examples of 'surface resistance' in a sentence
Meaning of "surface resistance"
surface resistance: Refers to the opposition or impedance encountered by an object as it moves across the surface of another material or substance
How to use "surface resistance" in a sentence
Basic
Advanced
surface resistance
Excellent surface resistance and low tack.
It was then conditioned in a desiccator before measuring the surface resistance.
Then the respective surface resistance was measured.
The surface resistance is greater than that of wood.
Implications of stump surface resistance are discussed.
Its surface resistance would then be as low as possible.
This results in a very low surface resistance of the strip substrate.
The surface resistance is of particular significance for printing papers.
The heat that can be produced in a pot is a function of the surface resistance.
Schemes without surface resistance to evapotranspiration performed particularly poorly.
Talc is preferably chosen to obtain a paper whose surface resistance is further improved.
The electrical and surface resistance should measure situation or application.
The surface conductivity was easily calculated from the value of the surface resistance.
A higher surface resistance produces more heat for similar currents.
The figures for the standardized specific surface resistance are compiled in the table below.
See also
This is the surface resistance of a dielectric substance to insulation as well as electricity.
The thermal properties were measured by means of the electrical surface resistance and the emissivity.
The electrical surface resistance and the emissivity are extremely low.
The median portion may include different coatings each with a distinct surface resistance.
There is no mention of the surface resistance of the electrolessly plated film.
There are those using one or more thin resistive sheets with an appropriate surface resistance.
The values for the surface resistance relate to a measurement carried out as follows.
High dimensional stability & excellent surface resistance.
This surface resistance is sufficiently low for many applications that require antistatic properties of a surface.
It should also be noted that both the surface resistance and bulk resistivity are important.
The surface resistance of the coating obtained is,.
Polymer layer, having a high surface resistance.
The coating film had high surface resistance so that sufficient electrical insulating property was exhibited.
Electrically conductive wall, electrical and surface resistance.
Moreover, the surface resistance properties of the laminate remained at a good level.
For a saturated homogenous system, the surface resistance.
Thereafter, the surface resistance was measured from the top of the binder film.
Can measure temperature / humidity at the same time as the surface resistance value.
In this way, changes in skin surface resistance cause little effect on the current density.
The layer of chromium provides the mask 4 with adequate surface resistance against abrasion.
The material of the surface resistance layer 22 is not limited to the foregoing acrylic resin.
The semi-aniline finishing uses resins, lacquers and auxiliaries for the leather surface resistance.
If they bleed, only the surface resistance decreases, and the volume resistivity does not vary.
After these antennas have been dried their specific surface resistance is greater than 200 kΩ.
The surface resistance was then measured and the results are provided in Table 2 below.
Furniture - Assessment of surface resistance to dry heat.
Its surface resistance is approximately 50 ohms.
Furniture - Assessment of the surface resistance to scratching.
Surface resistance values of up to < 107 ohm have been achieved in tests using cesium ions.
Furniture - Assessment of a surface resistance to wet heat.
Parameters for surface resistance modelling, especially for semi-natural vegetation, need to be collected and evaluated ;.
Handle is electrostatically conductive, surface resistance 1 megaohm to 1 gigaohm.
The surface resistance measured from the sample extruded from the polymer blend was 2 x 109 ohm.
Furniture - Assessment of surface resistance to cold liquids.
Fixed parameter values were taken for albedo, leaf-area index, canopy cover and surface resistance.
You'll also be interested in:
Examples of using Surface
Show more
An uneven surface increases the risk of overturning
Where ϑ is the measured test surface temperature
All feasible surface and subsurface ECVs
Examples of using Resistance
Show more
National resistance to the occupation was therefore legitimate
This must result in a resistance value of approx
Resistance to surface damage by fine particles optional
