Examples of 'turn on power' in a sentence
Meaning of "turn on power"
This phrase is used to describe the action of activating or providing electrical power to a device, appliance, or system. It usually involves switching on a power source or pressing a button to initiate the flow of electricity and enable the functioning of the device
How to use "turn on power" in a sentence
Basic
Advanced
turn on power
Turn on power to appliance and ignition module.
Shukla sir did not turn on power button.
Turn on power and check ventilator operation.
Set the power switch to on to turn on power to the printer.
Turn on power handle and lightly follow.
Place foot controller at your feet and turn on power switch.
Turn on power to the flowmeter if it is not already powered up.
It is not necessary to turn off and turn on power supply of the controller.
Turn on power and check operation of the blower.
Check power switch Turn on power switch.
Turn on power again and start the unit.
Connect the AC power cord and turn on power.
Turn on power and master switch.
Pressing POWER while USB power is off does not turn on power immediately.
Turn on power at the circuit breaker or fuse box.
See also
For direct wire installation, turn on power.
Turn on power to the interlocking wheels.
Connect the device as shown on the pictures, turn on power.
Turn on power by pressing the main power switch.
Connect MicroSD card and ethernet cable to box, then connect and turn on power.
Turn on power to circuit at service entrance.
Before refilling crankcase with oil, briefly turn on power to the compressor motor 2-3 seconds max.
Turn on power to the supported device.
Cards are not discharged . Card is jammed . Turn on power to reader / writer.
Turn on power to the circuit being measured.
Connect the spectrophotometer to the computer and turn on power see page A-3.
Turn on power and repeat the above heating test.
Press the 1 P button to turn on power.
Turn on power again and check the time display.
ON / CANCEL BUTTON, Press the button to turn on power to the base.
Turn on power supply or plug power cord into outlet.
Press the STANDBY / ON button to turn on power again to the PRV-LX1.
Turn on power and check operation of fan and light.
PMR Operation - Press and hold the POWER On / Off button for 2 seconds to turn on power.
Turn on power to circuit being tested.
Then press the front-panel's STANDBY / ON button to turn on power.
Turn on power to the torpedo.
Pull trigger then turn on power switch located on back of pressure washer.
Turn on power to the oven at the circuit breaker or fuse box.
Device does not turn on Power cable is not properly con.
Turn on power only when the installation is completed and verified.
The radio does not turn on Power supply cable disconnected or defective.
Turn on power to medium speed and press switch lock out button.
Washer will not turn on Power cord is not properly plugged in.
Turn on Power Save again once the battery has been reconnected.
Do Not turn on power until installation is completed.
Turn on power See Use and Care Guide that came with your vent hood system.
DO NOT turn on power while the unit is charging for the first time.
Turn on power to set the height, or it will be.
Turn on power to the chair ; program as needed.
