Examples of 'turn the lever' in a sentence
Meaning of "turn the lever"
turn the lever - This phrase typically means to rotate or move a lever in order to operate a machine or device. It is often used in a literal sense to describe physically turning a lever to activate a mechanism or control a process
How to use "turn the lever" in a sentence
Basic
Advanced
turn the lever
Turn the lever counterclockwise to loosen the.
How about you turn the lever.
Do not turn the lever using your hands.
To increase the strength turn the lever clockwise.
Turn the lever clockwise to lock the printhead.
Look at your watch and turn the lever every ten seconds.
Turn the lever to the mark.
Without power liftgate Turn the lever to the right to unlock the liftgate.
Turn the lever clockwise to secure the sprocket.
To release the brake, turn the lever counterclockwise.
Turn the lever to the right to unlock the liftgate.
To release the brake, turn the lever fully anticlockwise.
Turn the lever clockwise to release the adjusting plate.
For rotation only, turn the lever to the position of symbol.
Turn the lever slowly.
See also
Use the supplied adjustment key to turn the lever picture 5.
Lift and turn the lever on the left hinge.
When the high spot is passed, turn the lever back.
Then turn the lever upwards in one continuous movement.
When the ice cubes are made, turn the lever clockwise.
Turn the lever again.
For rotation with hammering, turn the lever to the position of symbol.
Turn the lever until the required amount of coffee is obtained.
To engage the safety lock, turn the lever towards the symbol.
Turn the lever under the saddle by hand and loose.
Close the battery cover, and turn the lever to the mark.
Turn the lever counterclockwise until the sprocket cover comes off.
To adjust the height setting, turn the lever to the desired height setting.
Turn the lever for the cutting depth limiter to set the required cutting depth.
To change the cutting action, just turn the lever to the desired cutting action position.
Turn the lever to CLOSED until the engine is warm.
Insert the battery container into the battery compartment and turn the lever 90 degrees clockwise.
They should turn the lever if they want to escape.
Set the desired dimension and turn the lever ( 8 ) down.
Turn the lever clockwise to the OFF position and push it inwards.
To reduce the cutting height, turn the lever in the opposite direction towards the " - " mark.
Turn the lever to the 0 position to reset.
Open both valves all the way … then turn the lever to the 3 o'clock position.
Turn the lever clockwise - the discharge turns to the right.
Let us do this, How about you turn the lever - and say the number out loud.
Turn the lever to the mark, and slide the battery cover to open it.
Environment temperature is higher than 10 C, Turn the lever to normal position sun mark.
To close, turn the lever against the direction of the arrow until it stops.
Environment temperature is equal or lower than 10 C, Turn the lever to anti-icing position snow mark.
If you turn the lever to the left, you gradually obtain hotter water.
Let's do this: How about you turn the lever.
To disengage it, turn the lever so that it points towards the symbol.
Turn the lever to loosen the angle guide on the cutting guide Fig 3.
To apply the tilt brake, turn the lever ( 4 ) fully counterclockwise.
Turn the lever counter-clockwise fig.
You'll also be interested in:
Examples of using Turn
Show more
Persuade him to turn over a new leaf
Now turn around and meet him
The unit does not turn on when installed
Examples of using Lever
Show more
Do not lift lever during brewing cycles
Lever can be adjusted to a different lever angle by
Open the lock lever to unlock footplate
