Examples of 'unthread' in a sentence
Meaning of "unthread"
Unthread is a noun that refers to a discontinued or loose thread, often used in the context of sewing or fabrics
Show more definitions
- To draw or remove a thread from.
- To loosen the connections of.
- To make one's way through.
How to use "unthread" in a sentence
Basic
Advanced
unthread
Unthread the thumbscrews on the diagonal mirror.
An advantage is that in situ the assembly is unable to unthread itself.
Unthread the two threads of the needles.
Reach inside the solution tank and unthread the solution fi lter to remove.
Unthread the thumbscrews on the focuser tube.
Remove the spigot from the lower container and unthread the handle.
Unthread the eye of the needle to be changed.
It is also possible to use the reverse possibility to unthread a line from a mooring ring.
Unthread the catcher from the threaded rod.
Use an 8 mm flare nut wrench to unthread the compression nut.
Unthread the poppet valve cover slowly by hand.
Turn the wrench counter-clockwise to unthread the air can.
Unthread the connector from the valve stem.
Record the air pressure, then unthread it from the shock.
Unthread strap from belt adjuster.
See also
To remove the vacuums shoes, unthread the vacuum shoe knob.
Just unthread it through the thing.
Record the air pressure value on the pump, then unthread it from the shock.
Unthread the internal seal head three full turns.
Strike long arm of wrench sharply counterclockwise, remove wrench and unthread chuck from spindle.
Unthread the bleed syringe from the bleed port.
While holding onto the pump, use an adjustable wrench to unthread pump nut from pump.
Unthread the hex nut halfway up the adjustment screw.
Unclip both shoulder harnesses from the side release buckles and unthread them from the O-rings.
Unthread two screws in the back of the telescope tube.
Remove handle and unthread trim cap 4.
Unthread and disconnect all unions in the support equipment area.
Then using a 3 phillips screwdriver, unthread the screw from the unit.
Unthread the needle to help you determine the zigzag width.
To remove, review section 4-A to unthread the harness system.
Unthread the gas cap to add gasoline to the fuel tank.
You may need to unthread the catcher slightly to check the bushing pin spacing.
Unthread the four cover fixing tabs from the edge of the.
Use the tool to unthread the sleeve and remove the sleeve and coupler.
Unthread and remove the poppet valve housing from the inner shaft.
Using a 9 ∕ 16 in wrench, unthread the check valve fitting and remove it from the pump.
Unthread adjuster to get tighter braking action or thread adjuster in to reduce braking action.
Tool to unthread the inner bearing race of the clutch shaft.
Unthread the push pin from the threaded rod to remove the bushing pin.
Carefully unthread the inlet filter and clean it with penetrating oil.
Unthread valve cap and remove wiper seal and duck bill valve to clean.
To unthread text.
Unthread the poppet valve cover from the poppet valve housing three full turns.
Unthread and remove the strain relief nut and hose assembly from the poppet cover.
Unthread barbed fitting with check valve and rinse fitting and check valve with clean water.
Unthread and remove the hose coupler from the Connectamajig coupler.
Unthread the seal head and wipe the excess fluid away from the o-ring.
Unthread the head from the can of the inflator Figure 1.
Just unthread it through the thing, it 's very simple.
Unthread and remove oil fill cap / dipstick ; wipe oil off.
