Examples of 'valve is closed' in a sentence
Meaning of "valve is closed"
valve is closed: This phrase indicates that a mechanical device used to control the flow of a substance is in a shut or sealed position
How to use "valve is closed" in a sentence
Basic
Advanced
valve is closed
The service valve is closed during operation.
Ensure that the drain valve is closed.
The valve is closed and remains closed.
Make sure that the valve is closed.
This valve is closed in the reclaiming phase.
Ensure the tank drain valve is closed.
The valve is closed when its rolled up.
The cold water feed valve is closed.
The drain valve is closed after a few seconds.
Make sure the pressure valve is closed.
The valve is closed on completion of the heating cycle.
The receiver service valve is closed during shipment.
The valve is closed so there is no flow.
Afterwards the valve is closed again.
The valve is closed again afterward.
See also
And our steam valve is closed.
The valve is closed when the cannula is withdrawn.
The water supply valve is closed.
The bypass valve is closed during normal operation.
Check to be certain the gas ballast valve is closed.
The valve is closed when the electrification is stopped.
Ensure the drain hose gate valve is closed.
The fuel valve is closed or there is no petrol in the tank.
Otherwise the water valve is closed.
The fuel valve is closed or the fuel tank is empty.
Please then check whether the valve is closed.
The fuel valve is closed automatically if the engine stops.
The normal position of this valve is closed position.
The valve is closed again and the cycle is recommenced.
The corresponding selection valve is closed.
The valve is closed and the pump pulled out.
In the figure the valve is closed.
Each exhaust valve is closed by a respective supply valve when it is opened.
Likewise if there is decrease in demand the valve is closed.
The forward valve is closed.
Gas supply is turned off or equipment shutoff valve is closed.
Then the valve is closed.
All values are recorded till the dispensing valve is closed.
The inlet valve is closed.
But a particular problem arises when a squeeze valve is closed.
The exhaust valve is closed.
The valve is closed when the pipe is filled up with hydrogen.
At this time the steam supply valve is closed.
When the valve is closed the flow of washing liquid is blocked.
Initially the valve is closed.
The input valve is closed and the highpressure pump is switched off.
After a period of inflow the valve is closed to permit recovery.
This valve is closed in the vicinity of the next top dead center.
The electromagnetic valve is closed.
The dispensing valve is closed during the entire exhalation phase.
