Examples of 'valve shall' in a sentence
Meaning of "valve shall"
Valve shall: A phrase commonly used in technical or engineering contexts to describe a mandatory requirement or specification related to valve operations, maintenance, or design. The term 'shall' indicates a firm and binding obligation, indicating that a certain action or condition must be met. For example, 'The valve shall be able to withstand high pressure' implies that the valve must have the capacity to handle and resist high pressure
How to use "valve shall" in a sentence
Basic
Advanced
valve shall
The cylinder valve shall always be opened slowly.
The set pressure of a pressure relief valve shall be.
The valve shall be so regulated as not to open during carriage.
The setting of the tank relief valve shall be identical.
The internal valve shall immediately start to close upon actuation.
B In the Commonwealth of Massachusetts a pressure relief valve shall be installed.
The pressure relief valve shall be so designed as to open at a pressure.
A factory installed, float operated, mechanical make-up valve shall be included.
An automatic cylinder valve shall be installed directly on each container.
A vacuum valve and a high-velocity vent valve . The valve shall.
The excess flow valve shall be mounted inside the container.
If not embodied in the opacimeter, a by-pass valve shall be provided upstream.
The valve shall meet the following performance qualification requirements.
Isolation valve shall be.
A valve shall not be installed downstream from an atmospheric vacuum breaker.
See also
The electrical connection to the rotary valve shall only be made by an electrician.
A nonreturn valve shall be fitted at the junction between the water suction.
Energy for microdetonation of the gas release valve shall be provided by the Auxiliary Battery.
The safety valve shall be pressurised according to the working pressure used.
Rubber packers equipped with a quick acting shut-off valve shall be provided for each grout hole.
No valve shall be placed between the relief valve and the water heater.
A functional check for each valve shall be carried out once in a driving cycle.
The valve shall open and close within 1 s of the start and end of test.
Before leaving the factory, the valve shall be tested as follows,.
A nonreturn valve shall be fitted between the feed tanks and the meter.
A vacuum valve and a high-velocity vent valve . The valve shall be so.
The pressure relief valve shall be so regulated as not to open during carriage.
The set pressure of the vacuumrelief valve shall be 3.5 kPa.
The safety valve shall be sensitive and reliable and shall be checked regularly.
A blowdown line with metering valve shall be connected directly to the tower overflow.
No shutoff valve shall be installed between the relief valve and the system.
After the pressure has fallen, the valve shall be closed for a recharge of the accumulators 55.
The valve shall be switched to start the flow of zero gas ;.
A functional check of the valve shall be carried out once in the driving cycle.
Which valve shall I take out? How about her heart?
Amend the seventh paragraph ("Each valve shall have a taper threaded connection… ") to read as follows.
The service valve shall withstand a pressure of 6,750 kPa in the open and closed position.
The LNG primary relief valve shall not vent into the gas tight housing if fitted.
The excess flow valve shall be designed with a bypass to allow for equalization of pressures.
The high-velocity vent valve shall be so regulated as not to open during carriage.
The excess flow valve shall be designed with a bypass to allow for equalisation of pressures.
In this case, the vacuum valve shall be set to relieve at this lower pressure.
The excess flow valve shall cut off at a pressure difference over the valve of 90 kPa.
The LNG secondary relief valve shall not vent into the gas-tight housing if fitted.
The automatic valve shall be so designed to operate at temperatures as specified in annex 5O.
The pressure relief valve shall not have internal leakage up to 2600 kPa.
The non-return valve shall be so designed to operate at temperatures as specified in Annex 5O.
An automatic valve shall be installed in each CNG container.
Further, the valve shall easily be made self-draining.
O only one valve shall control the " drip drain " piping system.
You'll also be interested in:
Examples of using Shall
Show more
The measured values shall be plotted on a graph
We shall hit them from all sides
Repayment of principal shall be made in equal instalments
Examples of using Valve
Show more
Lift the valve assembly up and out
Grasp black lever on one drain valve
Check valve assembly caps to ensure tightness
