Examples of 'vent length' in a sentence
Meaning of "vent length"
Vent length refers to the measurement or dimension of a ventilation system or duct. It specifies the distance or length of the air passage through which air is circulated, allowing for proper airflow, ventilation, or exhaust in a particular space or system
How to use "vent length" in a sentence
Basic
Advanced
vent length
Vent length is given as a general reference only.
Côté sous le vent length.
Equivalent vent length measured from this position.
The vent terminal does not contribute to the overall vent length measurement.
Determine vent length and elbows needed for best drying performance.
The following length equivalents are for use when figuring vent length.
The minimum vent length protruding from outside the wall is ten inches.
The following example falls within the maximum recommended vent length.
Exceeding the maximum vent length is dangerous and may result in bad combustion.
Do not use vent runs longer than specified in exhaust vent length charts.
Vent length necessary to connect elbows H.
Do not use vent runs longer than specified in the Vent Length Chart.
Adjust for Vent Length indoor models only.
Refer to the sec on on Maximum Vent Length.
Vent length necessary to connect elbows 8.
See also
Do not use vent runs longer than specified inthe Vent Length Chart.
If vent length requirements are not followed, the wall furnace will not operate properly.
IMPORTANT, Do not use vent runs longer than those specified in the Vent Length Chart.
Snout to vent length greater than 8 cm.
Adults have an average snout to vent length of 64mm.
Snout to vent length (SVL) is used to assess tadpole growth as illustrated in Figure 2.
The first 90 elbow must be considered into the total vent length.
Next, determine the equivalent vent length using chart on Page 5.
The total vent length including horizontal & vertical vent runs should be no less than 0.9m 3.
Rigid metal or flexible metal vent 7, Vent length necessary to connect elbows 8.
Equivalent Vent Length ( EVL ) Recommended venting system inner pipe diameter is 3 ”.
Chamaeleo senegalensis (ranched specimens with snout to vent length greater than 6 cm) from Benin;.
In Egypt the snout vent length of the toads varied between 26 and 36 millimeters.
The minimum horizontal vent length is three feet 914mm.
You'll also be interested in:
Examples of using Vent
Show more
Plastic or metal foil vent is not recommended
Clear vent area of dust and debris
Leave the bottom vent slightly open
Examples of using Length
Show more
Tubing length and elevation difference limits
Cut wire liner at the right length
Only the length of the journey differs
