Examples of 'voltage applied' in a sentence
Meaning of "voltage applied"
Voltage applied refers to the amount of electric potential difference that is provided to an electronic device or system. It is the measurement of the force that drives the flow of electric current through a circuit. The voltage applied determines the intensity and power of the electrical system
How to use "voltage applied" in a sentence
Basic
Advanced
voltage applied
Voltage applied to the stationary electrical contact.
It exhibits good electrical conductivity at a low voltage applied.
The voltage applied to the cell.
Piezoceramics are known which are elongated according to the voltage applied.
Voltage applied to industrial standard consumers kV.
One of these electrodes has a fixed focus voltage applied.
The voltage applied to the motor.
Damage to your fixture may result if the line voltage applied.
If the voltage applied to these electrodes is increased to a greater amplitude.
The intensity of the radiation transmitted is a function of the voltage applied.
Vout voltage applied to the load by the output port.
The continuity of the busbar is firstly that of the voltage applied.
Vin voltage applied to the input port by the source.
The viscosity may change depending on electric field or voltage applied.
The voltage applied varied depending on the capillary length.
See also
This arrangement enables the voltage applied to each transistor to be reduced.
The voltage applied for a duration of the order of a few hundreds of ms.
The amperage depends on the voltage applied and the winding resistance.
The voltage applied to the heating tape was controlled by means of a rheostat.
Device for automatically controlling a voltage applied to a data conductor in a serial link.
The voltage applied across the electrodes may be cycled or swept.
Surface was complemented by high voltage applied to the wire and a lot of watchtowers.
A voltage applied results in transmissivity and no voltage applied results in opacity.
Is the amplitude of the voltage applied to the input of the electrodes.
Greater reactance leads to smaller currents for the same voltage applied.
Lowering the voltage applied at a higher temperature maintains safety margins.
Lighting of the diode can be controlled by the voltage applied to the gate.
The voltage applied to the gate electrode tries to charge the capacitor.
The switch may be actuated by controlling the voltage applied to its gate.
The voltage applied can thus be reduced without the electroluminescene ending.
We have therefore achieved a spectrophotometric analysis by varying a voltage applied to the modulator.
Thus the voltage applied to the excitation winding is variable over time.
The resistance of such materials diminishes as the voltage applied thereto increases.
A bias voltage applied to the terminals of the sensor leads to a photocurrent being generated.
The final film barrier thickness is proportional to the peak voltage applied.
The voltage applied by the bridge changes sign and becomes negative.
The pump speed is proportional to the voltage applied to the pump motor.
Any external voltage applied to a digital input may seriously damage the unit.
This current depends very greatly on the levels of voltage applied to the resistor.
The electrical voltage applied between the electrodes can then be a voltage ramp.
The position of the switch depends directly on the value of the voltage applied.
The zero voltage reference is the voltage applied to the sources in reading mode.
The voltage applied to the electrodes varies the concentration of ions in the conductor.
This produces a decrease in the output voltage applied to the cutting tip of an electrode.
The voltage applied to the inner and outer electrodes can be varied independently.
The acceleration energy is thus controlled solely by the voltage applied to the substrate.
The control voltage applied to the crystal periodically modifies its refractive index.
The maximum attenuation of this attenuator may be adjusted as a function of the voltage applied.
The magnitude of voltage applied is particularly important in the case of switched reluctance machines.
The time needed for untrapping varies inversely with the voltage applied.
You'll also be interested in:
Examples of using Applied
Show more
One caveat must be applied to this analysis
We applied three event history analysis methods
It may also be contested as applied in a certain investigation
Examples of using Voltage
Show more
Voltage drop due to use of extension cable
Information on the voltage is on the rating plate
Voltage measure switch for phase voltage
