Examples of 'wire size' in a sentence
Meaning of "wire size"
wire size ~ This phrase refers to the measurement or thickness of a wire. It is often used in electrical or wiring contexts, where the appropriate wire size is important for safety and functionality. The wire size can determine the amount of current it can carry without overheating or causing damage
How to use "wire size" in a sentence
Basic
Advanced
wire size
Extension cord wire size too small.
Extension cord too long or wire size.
Model fastener wire size max length.
Use only the recommended wire size.
Maximum wire size and maximum overcurrent protection.
Find the minimum wire size to use.
Check wire size from main switch to pump.
Zone sensor maXImUm lenGth anD wIre sIze.
Extension cord wire size requirements.
Wire size must conform to the requirements of the.
Minimum extension cord wire size requirements are as follows.
Wire size capacity gauge label.
See next page for appropriate wire size.
Increase wire size or reduce inertia.
Different technology data according to different wire size.
See also
The wire size should be same size as the battery wire.
Extension cord too long or wire size too small.
Select wire size and connectors according to national and local codes.
Be sure that the electrical connection and wire size are.
Core wire size.
Select the opening which matches your wire size.
Observe local regulation regarding wire size selection and installation.
Each individual extension contains at least the minimum wire size.
Tool model nail series gauge wire size fastener range.
The wire size is the minimum value for metal conduit wiring.
Extension cords must fit the following wire size guidelines.
That wire size is at least as large as the one specified in the table.
An extension cord must have adequate wire size for safety.
Use the wire size table as a guide in selecting minimum conductor size.
Install proper drive roll for the wire size selected.
Check that wire size is rated for the current of the compressor.
Refer to the table shown to determine the required minimum wire size.
The drive roller has two wire size grooves built into it.
Refer to the table at right to determine the required minimum wire size.
Each drive roller has two wire size grooves built into it.
You can see how important it is to choose the correct wire size.
The power and ground wire size should be the same gauge.
Replace with the proper tip for the wire size used.
Wire size and connections must conform with the rating of the appliance.
Consult motor manual to determine the wire size for the application.
That wire size is large enough for ac ampere rating of charger as specified above.
A heavier cord with a larger wire size will reduce the voltage drop.
Wire size must comply with the applicable local and national code.
Select circuit protection and wire size according to the unit rating plate.
The wire size must be adequate to carry the current required by this charger.
Select the opening in the stripping lever that matches the wire size.
Use the largest wire size and shortest length for the application.
Make sure gun liner and tip are correct for wire size being used.
Wire size must match the electrical load connected to the switch contacts.
Be sure the liner bushing is stencilled appropriately for the wire size being used.
You'll also be interested in:
Examples of using Size
Show more
Change duct size gradually to minimize turbulence
I do not want a comedian knowing my dress size
Size expressed as minimum and maximum weight
Examples of using Wire
Show more
Steel wire liners can be coated or noncoated
Use a passage aid wire or previous cord
Cut wire liner at the right length
