Examples of 'wire speed' in a sentence
Meaning of "wire speed"
wire speed: Refers to performing tasks or actions at a very high speed or pace, often used in the context of technology or rapid performance
Show more definitions
- The speed at which a wire moves through a machine
- The (maximum) rate at which data can flow through a cable
How to use "wire speed" in a sentence
Basic
Advanced
wire speed
The welding wire speed is not constant.
Wire speed across all ports.
Adjust heat setting and wire speed as needed.
The wire speed should be adjusted to provide a steady arc.
The welding intensity depends on the wire speed.
Tune in the wire speed as if you were going to make a continuous weld.
The easy way to measure the wire speed.
This wire speed value is automatically adjusted if the potentiometer is.
Adjusting this knob changes the welding wire speed.
Wire speed will change if changes are made in the voltage control.
Gpbs aggregated throughput full wire speed forwarding rate.
Progressively select higher voltage positions while increasing wire speed.
Adjusts the welding wire speed when using manual programs.
This control knob is used to set the required wire speed.
Permits adjustment of the secondary wire speed in the bilevel welding mode.
See also
The tachometer provides feedback to regulate and record wire speed.
Excessive wire speed can be corrected through the arc voltage increase.
And a reduced wire speed.
The wire speed shown is the speed that will result from the displayed voltage.
A smooth buzzing sound indicates the wire speed is properly tuned.
Adjust the wire speed and the welding voltage using the knob AI.
In synergic mode will adjust the wire speed as the main parameter.
With the potentiometer you can select the needed wire speed.
Allows regulation of the wire speed value during the weld closing phase.
Indicates that the display AL shows the wire speed in welding.
Changes in wire speed are always indicated on the display H by a current.
Select the manual mode to set the desired ratio between wire speed and welding voltage.
Adjust the wire speed with the potentiometer2.
CrC crater filling time expressed as a percentage of the welding wire speed.
Each set corresponds to a value of wire speed Vf and defines an operating point.
TheAL display shows the recommended thickness based on the set current and wire speed.
Turn on the welder and set the wire speed rate to Maximum.
The AL display shows the recommended thickness based on the set current and wire speed.
Selecting the value of Wire Speed or Amp parameters.
When wire speed is increased, welding amperage increases.
Turn on the welder and set the wire speed rate to 8.
If the wire speed increases, the welding current value will.
When an arc is being drawn, the wire speed will slow down.
Network switches, routers, and similar devices are sometimes described as operating at wire speed.
In synergic mode, the wire speed will always be set as the main parameter.
With this function, there is no need to adjust the wire speed.
Wire speed forwarding capability of all ports make sure of non-blocking message forwarding.
A certain welding current results, conditional upon the wire speed.
Adjust the wire speed and the welding voltage using the knob AI . and AN respectively.
In manual mode only, this function displays accurately the wire speed setting.
The wire speed adjustment is often determined « by the noise ».
In this mode, the device determines the optimal wire speed according to 3 parameters.
If you hear a popping sound, or struggle to maintain the arc, adjust the wire speed.
The wire speed adjustment is often determinated « based on sound ».
This exclusive design allows you to adjust the wire speed right on the gun!
You'll also be interested in:
Examples of using Speed
Show more
The speed of the vacuum source shall be
I must have hit speed dial by mistake
Zoom speed is determined by the amount of rotation
Examples of using Wire
Show more
Steel wire liners can be coated or noncoated
Use a passage aid wire or previous cord
Cut wire liner at the right length
