Examples of 'auger control' in a sentence
Meaning of "auger control"
This phrase refers to a system or mechanism used to regulate and control the operation of an auger, which is a type of rotating device or tool often used for drilling or digging. It can be associated with various applications where augers are employed, such as construction, agriculture, or manufacturing
How to use "auger control" in a sentence
Basic
Advanced
auger control
Auger control cable not adjusted correctly.
Do not hold the auger control switch operated.
Auger control switch has been operated frequently.
Start engine and verify auger control engages and disengages properly.
Auger control cable in need of adjustment.
Lower the auger to the lowest position with the auger control switch.
Engage the auger control for several seconds.
Wait for all moving parts to stop before readjusting the auger control cable.
Squeeze the auger control to engage the augers.
Refer to the Assembly section for instructions on adjusting the auger control cable.
Auger control against the handle.
To adjust the auger control cable D.
The auger control rod is installed on the snow thrower.
The auger must stop within 5 seconds after the auger control is released.
Make sure auger control is disengaged.
See also
The auger must disengage within 5 seconds after the auger control is released.
When the auger control is released and in the disengaged.
To engage augers and start throwing snow, squeeze the auger control against the left handle.
Operate the auger control switch while the engine is running.
To engage the auger and start throwing snow, squeeze the auger control against the handle.
Releasing the auger control lever will disengage the auger.
Refer to the Assembly and Set-up section for instructions on adjusting the auger control cable.
Squeeze the auger control and the augers will turn.
After replacing the auger belt, perform the Auger Control.
Release the auger control lever and shut offthe engine.
NOTICE, The auger must not turn unless the auger control is engaged.
Release the auger control lever and shut off the engine.
Allow the auger to remain engaged for approximately ten ( 10 ) seconds before releasing the auger control.
Engaging the auger control will ease removal and reinstallation of the belt.
Loosen the hex jam nut on the auger control cable “ Z ” fitting.
Squeeze auger control lever to handle to engage the auger and throw snow.
Start unit and engage auger control A, Figure 9.
Squeeze the auger control lever to the handle to engage the auger and throw snow.
Remove plastic tie ( A ) securing auger control rod ( B ) to lower handle.
Perform the Auger Control test outlined in the Assembly section of this manual.
Fully press and hold the auger control ( B ) to engage the auger rotation.
Auger control lever - used to engage auger motion throw snow.
Make certain both the auger control and drive control are in the disengaged ( released ) position.
Repeat Auger Control Test to verify proper adjustment has been achieved.
Release the auger control lever to stop throwing snow, ENGINE.
Adjust auger control cable as shown in Maintenance & Adjustments section.
Release the auger control lever ( B ) to stop throwing.
Moreover, the auger control may be configurated for automatic repetition of the sequences of operation.
Operating the auger control switch while the engine is OFF will cause dead battery.
Refer to Auger Control Test prior to operating your snow thrower.
While the auger control is engaged, squeeze the drive.
Release the auger control lever to stop throwing snow, AUGER CONTROL LEVER.
With the auger control lever in the disengaged “ up ”.
The auger control rod ( A ) has the short loop on the end of the spring.
Adjust auger control cable as shown in “ Adjusting Auger Cable ” section.
You'll also be interested in:
Examples of using Auger
Show more
Dismantle the auger belt as described above
Auger blades and drilling points are sharp
Check the auger paddles for wear
