Examples of 'bending fatigue' in a sentence
Meaning of "bending fatigue"
bending fatigue: a type of physical tiredness or weakness that is caused by repeated or prolonged bending movements
How to use "bending fatigue" in a sentence
Basic
Advanced
bending fatigue
Rotating bending fatigue testing.
The numerical results are compared to those of experimental bending fatigue tests.
Bending fatigue strength is measured according to the following procedure.
The effect of manufacturing method on bending fatigue of gear tooth.
Rotating bending fatigue tests are carried out with the test pieces shown below.
These wire ropes were further exposed to a repetitive bending fatigue test.
Cantilever bending Fatigue regime.
This jaw design is ineffective or less than efficient in resisting bending fatigue.
The flat belts provide traction and bending fatigue resistance advantages.
The portion between the toes and the metatarsus is dimensioned to resist bending fatigue.
The way of the bending fatigue tests are as follows,.
In contrast Prior Art III has an acceptable pressure drop but unacceptable bending fatigue strength.
For peripheral use, the bending fatigue is less important than pulsatile fatigue.
To withstand this increase in pressure, crankshaft demands higher torsional and bending fatigue strength.
Therefore, tooth bending fatigue will be reduced significantly extending the gear 's life.
See also
This experimental result can be verified by conducting a bending fatigue analysis on the expanded stent.
This bending fatigue test is carried out with an axial load of 980 g.
Thus, the medium must have adequate bending fatigue strength, to withstand this cyclic loading.
FIG . 9 shows a shape of a test piece produced for evaluation of the rotary bending fatigue properties.
Thirty-two strut specimens were studied in bending fatigue tests within four different test series.
Therefore, the bend 1 2 should be of a structure that minimizes bending fatigue.
Bending fatigue limit ( BFL ) were determined for all of the samples.
However, Prior Art II illustrates the trade off between bending fatigue strength and pressure drop.
The wet bending fatigue properties were determined in the Alma test ( Fig . I ).
The fatigue behaviour is studied by simulations of 4-point bending fatigue tests.
B bending fatigue experiment with a stress ratio R -1 tension threshold experiment with a stress ratio R 0 to - 0.1.
In some circumstances, the service life based on bending fatigue is reduced by more than 50 %.
Internal abrasion of T12 Technora rope caused by bending fatigue.
CCT ( Cyclic Corrosion Testing ) was performed on the Ono-type rotating bending fatigue test specimens 10.
You'll also be interested in:
Examples of using Bending
Show more
Steam bending is a traditional process steeped in history
Exceptional inverse bending test fatigue strength
Bending over in them tight little clamdiggers
Examples of using Fatigue
Show more
Fatigue was not considered a factor in this occurrence
Any perception of reform fatigue needs to be countered
No fatigue duty for the top ten
