Examples of 'bleed screw' in a sentence
Meaning of "bleed screw"
refers to a small valve or plug that is used to release air or fluid from a closed system, such as a hydraulic or plumbing system. It is typically opened slightly to allow air or excess fluid to escape, helping to maintain proper pressure and circulation within the system
How to use "bleed screw" in a sentence
Basic
Advanced
bleed screw
Put the pipe on the bleed screw.
Check the bleed screw fastening before sliding.
Fluid circuit bleed screw.
Open the bleed screw located at the highest point.
Waste oil will be ejected through the bleed screw hole.
Tighten the bleed screw to specification.
Bleed screw is not tightened before moving the log splitter.
On the bleed screw.
The oil space can be vented vÃa a bleed screw 30.
Install the bleed screw into the bleed port.
D Open the main water supply and flush one minute with bleed screw to clear debris.
Remove the bleed screw from the bleed port.
The container has no means of pressure relief except vÃa an air bleed screw 28.
Tighten bleed screw up before moving the log splitter.
The hole 12 is then closed by the associated bleed screw which is locked in position.
See also
Tighten the bleed screw if repositioning or moving the log splitter.
Therefore, there can be achieved the effect of rust-proof and anti-corrosion in the bleed screw.
Close the bleed screw before releasing the brake pedal.
Numeral 27 indicates the presence of a pressure gauge, and numeral 28 indicates the viewer bleed screw.
Cylinder bleed screw.
Loosen bleed screw by some rotations before operating the log splitter.
Connect the bleed reservoir to the bleed screw of the first cylinder to be bled.
Loosen bleed screw by 3-4 rotations before operating the log splitter.
Further, durability of the air bleed screw can be remarkably enhanced.
The air bleed screw 28 is threadedly engaged in the inner end of the inner 4.
Place a container under the bleed screw on slave cylinder and remove the bleed screw.
The bleed screw 188 then enables the air contained in the circuit to escape.
Tighten the bleed screw and then release the clutch lever.
Close the bleed screw again when you are finished splitting logs.
Systems without a bleed screw require a slightly different method to purge trapped air.
Tighten the bleed screw and then release the brake lever or brake pedal.
Air flow through the bleed screw should be detectable once the log splitter is started.
Loosen the bleed screw ( Q ) so the opening is clear of the housing.
