Examples of 'burst strength' in a sentence
Meaning of "burst strength"
burst strength: This term is used in engineering and materials science to describe the maximum stress a material can withstand before rupture or failure
How to use "burst strength" in a sentence
Basic
Advanced
burst strength
Burst strength may be measured on wet or dry samples.
Residual burst strength test.
Burst strength characteristics were tested.
This may provide increased burst strength to the surgical fastener.
The burst strength increased with increasing shell thickness.
The compression strength and burst strength of the linerboard is important.
Burst strength was measured and found to be within acceptable ranges.
The capsule may have any suitable inherent burst strength.
The measured burst strength was over seven times systolic pressure.
These wheel variations were tested for flexibility and burst strength.
The burst strength is that force that causes the sample to fail.
Calibrate the load cell according to the expected burst strength.
The values presented for burst strength are the average of three measurements.
Measured paper properties were light absorption coefficient and burst strength.
The bottles also exhibit improved burst strength in comparison with control samples.
See also
A common property for assessing mechanical strength of paper is paper burst strength.
The pressure must be less than the burst strength of the tube material.
In this instance the adhesive strength equals the ultimate burst strength.
Wet and dry burst strength was determined among the other tests that were run.
Paper was then produced by the various samples and tested for burst strength.
Burst strength was at one time a major test for evaluating material for corrugated containers.
The samples tested and their wet burst strength values are set forth in Table VII.
The burst strength and SCT of test liner were also improved.
An average peak load for a representative number of samples is the Wet Burst Strength.
SCT strength and burst strength index values for the prepared handsheets.
All kinds of materials can be tested on the Ball Burst Strength Tester.
The Mullen burst strength is measured by means of a Mullen tester.
Figure 5 depicts the compression burst strength of several tapes.
Retention and Burst strength were recorded and results are shown in Table II.
An in-vitro test system was used to determine the burst strength of each formulation.
However, burst strength is still a property considered extremely important by many customers.
Important properties include absorbency, burst strength and specific shredding energy.
Similar burst strength and wear rate before and after accelerated ageing 4.
The membranes described therein have high filtration efficiency, air flow and burst strength.
The burst strength may be a peak in the capsule 's force versus compression curve.
Figure 4 depicts the improved burst strength achieved with the present formulation.
The burst strength is indicated by a peak in the capsule 's force versus compression curve.
Alignment of the polymer molecules can improve polymer properties such as tensile and / or burst strength.
By increasing chitosan concentration, suture retention value, average burst strength and elastic moduli increased significantly.
The burst strength of each part is substantially the same as that in Example 1.
For a balloon catheter, the contact must not significantly reduce the burst strength of the balloon.
Paper burst strength may be determined using a Messemer Buchnel burst tester according to SCAN P24.
Increasing the proportion of low bond-strength fibers lowers the container burst strength and facilitates root-penetration.
The burst strength of the membrane is preferably at least 10psi.
Bond Strength - The adhesive strength expressed in percent of ultimate burst strength.
The peak load ( grams ) is the wet burst strength for the sample.
Figure 6 is a schematic representation of the apparatus used to measure the Wet Burst Strength.
The lesser burst strength of the base 8 causes this to break before the top 10.
Figure 6 is a schematic cross-sectional view of the apparatus used to measure the Wet Burst Strength.
Further, the sachet 30 with relatively low burst strength also may be desired.
You'll also be interested in:
Examples of using Burst
Show more
Fountains of lament burst through mountains of sadness
I burst into places all the time
The whole stadium burst a gut laughing
Examples of using Strength
Show more
Your inner strength should be even stronger
That can only be achieved through strength
We ask for strength to surpass all understanding
