Examples of 'burst test' in a sentence
Meaning of "burst test"
burst test - This phrase is often related to the testing of materials or products to determine their strength or pressure resistance. A burst test involves applying increasing pressure to a sample until it ruptures or fails, providing crucial data on its performance under specific conditions
How to use "burst test" in a sentence
Basic
Advanced
burst test
Retesting is permitted for the burst test.
Burst test under hydraulic pressure.
Residual strength burst test hydraulic.
This test is done on a cylinder previously submitted to a burst test.
An example of burst test on an inflatable canoe.
Retesting for the burst test.
Burst test hydraulic.
Hydrostatic pressure burst test.
Batch burst test.
One finished container shall be subjected to the burst test.
Example of burst test.
Maximum stress and stiffness were determined from the burst test.
The burst test must not cause any fragmentation of the container.
The criteria adopted for the interpretation of the burst test are as follows.
The burst test shall not cause any fragmentation of the container.
See also
The sealing properties of different fibrin formulations were measured by the burst test.
Ball burst test samples were scaled down due to limitations in material dimensions.
Applicable subsections and paragraphs and burst test requirement for service equipment.
Start the burst test immediately at this point by pressing the start button.
In the table below the average values for the burst test is noted.
The burst test can determine and evaluate the ability of a sealant to prevent leakage.
The pressures used for these calculations shall be the design pressure and burst test pressure.
The burst test result is provided in a table below which follows the various examples.
Figure 2 is an explanatory view showing a burst test method.
The restrained burst test involves pressurizing the inside of the subject container with compressed air.
For type approval, the container shall meet the leak and burst test requirements.
The burst test essentially as described in Vilela et al.
The sealing strength can be measured e.g. by the burst test described above.
Burst test Ambient temperature pressure cycle test.
Ensure that the hose ( or any length ) has not been used in a burst test program.
The burst test result is provided in the table below, following the examples.
The coating batch test shall then be repeated; (b) Batch burst test.
The burst test is intended to demonstrate margin against burst during this " worst case " situation.
The results of the Burst test are shown in TABLE 16.
The Burst Test is a minimum of three-times greater than the Service Test pressure.
The results of the Ball Burst test are illustrated in Fig . 6.
Burst test was performed on 3 bags.
B21.3 . Requirement For type approval, the container shall meet the leak and burst test requirements.
Residual strength burst test ( hydraulic ) Verification test for service terminating performance in fire.
In the Mullin 's Burst Test waterproofness is also determined visually.
Then a burst test and a leak test as referred to under points (a) and (k) are carried out.
You'll also be interested in:
Examples of using Burst
Show more
Fountains of lament burst through mountains of sadness
I burst into places all the time
The whole stadium burst a gut laughing
Examples of using Test
Show more
Mechanical tensile test prehoistable navigation lights
A test with tripping is compulsory on installation startup
Before the test we had art class
