Examples of 'cable cross' in a sentence
Meaning of "cable cross"
Refers to a specific exercise or fitness equipment that involves using cables or pulleys to perform exercises targeting different muscle groups
How to use "cable cross" in a sentence
Basic
Advanced
cable cross
Your cable cross section must be.
Connecting the batteries Recommended cable cross section.
Cable cross section required to limit relative power loss to α.
Ensure that there is a sufficient cable cross section for the input and output wires.
Cable cross section calculation.
Battery capacity too low Replace the battery Cable cross section too small Replace the cable.
Cable cross section can be reduced in case of smaller solar arrays.
For recommendations for cable cross section see „.
Permitted cable cross sections for connecting to the wall thermostat are.
To connect to the computer, use a commercially available network cable cross cable.
The cable cross.
Fixed, pre-programmed measurement ranges representing the most common cable cross sections.
The cable cross section must correspond to the power capacity which is to be installed.
If that is insufficient, the cable cross section must be increased.
Permitted cable cross sections for connecting to the power supply unit for brand switches are.
See also
Please only use certified and flawless extension cables with a minimum cable cross section of 2mm ².
Determine the necessary cable cross section of the intake line using the diagram below.
She 's gonna go for the dual cable cross.
The required PV cable cross section depends on array power and voltage.
Use a suitable supply cable, H05RR-F or higher, with the right dimensions cable cross section.
In case of long DC cables, cable cross section may be insufficient.
The cable cross section should be at least 4 mm ².
With a cable length of up to 6 m, a cable cross section of 4 mm2 is required as a minimum.
Cable cross section for interconnection of batteries must be 25 mm ².
Table 1, Battery cable cross section and power loss.
Cable cross section too small Change the cable see table on page 23.
An example of a typical cable cross sectional configuration is shown in FIG . 11A.
Cable cross section too small Replace the cable 8, page 6.
For a cable length of up to 4 m, a cable cross section of 5 mm2 is required.
Note 1, highlighted cable cross sections, minimum cross section due to thermal limit.
N The power cable should have at least a cable cross section of 10mm2 8 Gauge AWG.
Maximum cable cross section 16 mm ² screw terminals.
