Examples of 'cap nuts' in a sentence
Meaning of "cap nuts"
Cap nuts are a type of fastener with a domed top that covers the end of a bolt. They are used to provide a finished look and protect the threads from damage
Show more definitions
- plural of cap nut
How to use "cap nuts" in a sentence
Basic
Advanced
cap nuts
Inspect the cap nuts and tighten.
Secure dome to emitter using three cap nuts.
Tighten cap nuts inside plenum.
Fasten the feet using the enclosed cap nuts.
Place cap nuts on axle ends.
Make sure that you tighten the cap nuts against one another.
The cap nuts are just for a rustique look.
Secure into place with cap nuts I.
Tighten all five cap nuts with a torque wrench.
Clamping strap top / strap bottom basic part cap nuts washers.
Loosen cap nuts inside plenum to rotate blower housing to desired position.
Finally, slip the upper board over the rods and finish them with cap nuts.
Loosen the five cap nuts and remove them along with the washers and spring washers.
To remove fixture cover, remove cap nuts I.
Check all screws, cap nuts and their protective.
See also
Install the front cover, and install the four 6 mm cap nuts.
Check all screws, cap nuts and protective coverings regularly and tighten as required.
Therefore hold the upper handlebar ( 1 ) at its highest point before loosening the two cap nuts.
The cap nuts will not fit on the ends of the axle?!
When installing the wheel, tighten all five cap nuts to a torque of 25 Nm.
Screw off cap nuts ( G ) on both sides and remove together with the washers F.
Fit the hand wheels ( G ) using star washers and cap nuts.
Remove two inner cap nuts ( Q ) from top of fixture cage H.
Secure into place with cap nuts 1 A.
Remove two ( 2 ) cap nuts and washers from side of.
Bolts 36 are inserted from under to engage with the cap nuts 35 and tightened.
Cap nuts 35 are secured by welding to six positions around the pump attaching opening 31b1.
Place fixture cover ( R ) over fixture cage ( H ) and secure with inner cap nuts Q.
Loosen the four cap nuts ( 7 ) and remove them together with the lock washers 8.
Raise canopy ( J ) to ceiling and thread cap nuts ( K ) onto mounting screws ( A ) and tighten securely.
