Examples of 'carriage bolt' in a sentence
Meaning of "carriage bolt"
a type of bolt used to fasten wood or metal components together, typically having a flat, rounded head and a square shank that resists turning when tightened
Show more definitions
- A type of bolt with a rounded head and a square shank which will not turn.
How to use "carriage bolt" in a sentence
Basic
Advanced
carriage bolt
Screw a carriage bolt onto the pull wire.
Apply a small piece of tape to spacer and carriage bolt.
Thread a carriage bolt onto the pull wire.
Temporarily remove nut and washer from center carriage bolt.
Thread spring nut on carriage bolt unit finger tight.
Hold a mounting bracket under the saw and feed a carriage bolt.
Loosen the carriage bolt and remove the wheel.
Slide the spring clip up the chemical hose and slide it onto the carriage bolt.
Remove knob and carriage bolt on one side of the.
Attach washer only to end of the Carriage Bolt.
Unscrew the carriage bolt and remove the wheel.
Holes must be pre-drilled in an object before can carriage bolt can be installed.
Insert carriage bolt into square opening of heater handle.
Square neck carriage bolt.
Insert a carriage bolt found in the manual bag into.
See also
Raise the side brackets into position, lining up hole 1 in bracket with carriage bolt.
Slide the carriage bolt into the slot on each sensor.
NOTE, Install forward carriage bolt first.
Insert carriage bolt and install knob for other side.
Secure the two sections together with the M6x45 carriage bolt and wing nut.
Make sure that each carriage bolt is seated properly in the handle.
Install remote cable bracket ( A ) to discharge chute with carriage bolt.
The center carriage bolt should line up with drilled hole in heat shield.
Loosely thread spring nut ( 8 ) onto carriage bolt.
Insert the carriage bolt through the leg and then through the bracket.
Locking nut knob / flat washer / carriage bolt 2 each.
Insert the carriage bolt through the right side hole from the outside of the unit.
Install 20 " tube with elbow into end rail clamps and tighten with 1 carriage bolt and 1 nut.
Using the pull wire insert carriage bolt and bolt plate through end of frame.
The carriage bolt 29 has a smooth head and can not be turned from the outside.
Fasten the parts with the carriage bolt ( b ) and the wing nut c.
Screw a carriage bolt ( B ) through hole in each side of grill lid and grill body.
Align the cord retainer ( C3 ) with the carriage bolt.
Product, Carriage Bolt for electric tower.
Attach bottle bracket ( D ) to handle with carriage bolt ( E ) and black plastic knob F.
Do not tighten carriage bolt at hole location 2 until heat shield is reinstalled . Step 6.
Place hex nut on 1/2 ” long carriage bolt to attach bracket weldment to base frame.
Cuestomized Carriage Bolt - manufacturer, factory, supplier from China.
Place second 1/2 ” long carriage bolt in remaining slot and secure using hex nut.
Thread a 1/2 " carriage bolt onto the pull wire and place a bolt plate over it.
Insert a 1/2 ” carriage bolt with bolt plate down through the frame and into hole 1.
You'll also be interested in:
Examples of using Carriage
Show more
Also clean the carriage encoder strip
Carriage of receptacles for hot air balloons
Lock motorhead carriage in its home position
Examples of using Bolt
Show more
Remove the bolt with a socket wrench
Bolt or clamp the saw to its support
Stiffener bracket bolt must be kept tightened
