Examples of 'hex bolt' in a sentence
Meaning of "hex bolt"
A type of fastener commonly used in mechanical and construction applications. It has a hexagonal head and is threaded along its shaft. Hex bolts are used to secure two or more objects together, providing a strong and reliable connection
How to use "hex bolt" in a sentence
Basic
Advanced
hex bolt
Be sure to tighten the hex bolt securely.
Hex bolt right hand threaded.
Slide one spacer over hex bolt.
Replace the hex bolt and tighten securely.
Retighten the rear hex bolt.
Hex bolt right hand thread ed.
Make sure the hex bolt is tightened securely.
Push up the lower guard to expose the hex bolt.
Remove the hex bolt at the primary linkage.
Every other hex bolt.
Tighten the hex bolt to the torque listed below.
When using pressure to turn the adjusting hex bolt.
Tighten hex bolt and nut wrench not supplied.
That is not a hex bolt.
Insert hex bolt through center hole in wheel rim.
See also
Insufficient tightening of the hex bolt may result in severe injury.
Loosen the hex nut securing the adjusting hex bolt.
Always tighten the hex bolt securely after changing.
Do not remove any screw other than the hex bolt.
Replace hex bolt and tighten hex bolt to torque.
Remove the belt keeper by removing the hex bolt that secures it.
Tighten the hex bolt to secure the angle head.
Return to the lower handle and tighten the hex bolt securely.
Tighten so that the hex bolt can still rotate freely.
The hex bolt hole in the handle should be on the left side.
Make sure that the adjusting hex bolt slips into place securely.
Push hex bolt thru spacer and hole in opposite side of caster fork.
Align the washer over the blade and insert the hex bolt.
Remove the hex bolt which caps the oil hole.
Finish securing chute control head by installing hex bolt and wing nut.
Insert the hex bolt through the hole on the drill.
Unhook the idler spring from the hex bolt on the auger housing.
Remove the hex bolt and hex nut from the negative cable.
Pivot the trap slightly above horizontal and tighten the hex bolt securely.
Loosen the hex bolt and nut wrench not supplied.
I also countersunk the holes so that the hex bolt head would sit flush.
Loosen the hex bolt and remove the angle head.
Now lower the stopper pole until it makes contact with the adjusting hex bolt.
The nut holds the hex bolt with certain tightness.
Fasten the steering wheel to the steering shaft with the hex bolt and large.
Adjust the lowest hex bolt to obtain the deepest depth of cut.
Insert the mixing blade into the shaft and secure it with the hex bolt.
The tightness of the hex bolt decides the clearance of the blades.
Newspaper found beneath a coarse-thread hex bolt.
Then tighten the hex bolt clockwise to secure the center cover.
To remove the slide door, loosen the hex bolt on the magazine.
Tighten the hex bolt by turning clockwise while pressing the shaft lock.
Next, lower the stopper pole until it makes contact with the adjusting hex bolt.
Slightly loosen the hex bolt next to the flat idler pulley.
A hex bolt and washer can be found on your tractor 's deck surface.
