Examples of 'hose barb' in a sentence
Meaning of "hose barb"
This phrase refers to a specific type of fitting or connector used in plumbing or irrigation systems. It implies that the component has a barbed or ribbed end designed for secure attachment to a rubber or vinyl hose by creating a tight seal
Show more definitions
- A short protrusion marked by ridges or dull barbs useful for securing a rubber hose or tube.
How to use "hose barb" in a sentence
Basic
Advanced
hose barb
Slide connector tube off hose barb.
Hose barb with barb strain relief nut.
Be certain tube is completely pushed on hose barb.
Hose barb can point up or down.
Slide suction hose onto hose barb.
Replace the remote hose barb only if it is damaged from impact.
Slide discharge hose onto hose barb.
Hose barb with nut cap for reusable and safe hose clamping r / rc Thread Connection.
Do not overtighten the hose barb.
Replace 90 elbow hose barb fitting into check valve.
Attach open end of suction hose to strainer hose barb.
Attach the open end of the hose to the hose barb connection on the regulator.
Stop when the hose is hand tight on the hose barb.
Install the adapter and hose barb in the pump 's.
Use your hand to block the open area in the hose barb.
See also
Cross section of a Büchner Flask . Note the hose barb pointing right for attaching a vacuum source.
Hold the hydraulic hose near the hose barb.
Unscrew 90 elbow hose barb fitting from check valve.
Slide a new compression fitting over the end of the hose with the new hose barb.
Now connect the welder gas line to the hose barb outlet on your regulator.
Place the open end of the priming hose into the Vacuum inlet hose barb 1.
Attach hose to 90 elbow hose barb fitting and tighten the clamp.
Connect a vacuum hose to the Vacuum Hose Barb 2.
The hose barb projection 72 includes a hose barb which provides for attachment to an inlet hose 74.
Another way to connect glassware is with a hose barb and flexible tubing.
A tubular hose barb projection 72 projects from the annular disc 68.
Apply DOT grease to the hose barb threads.
To empty the solution tank, pull the Solution Drain Hose ( A ) off the upper hose barb.
Place the supplied clear hose ( 7 ) onto the small hose barb located near the pump outlet.
Thread the Hose Barb ( F ) on the water pump outlet, hand tighten.
Loosen hose clamp and remove hose from 90 elbow hose barb fitting.
A vacuum source ( not shown ), connected to the hose barb connector 18 is activated.
You'll also be interested in:
Examples of using Barb
Show more
Barb turned in already for the night
There is a metal barb stuck on the table
Barb likes to listen just like you
Examples of using Hose
Show more
Store chemical hose so it is protected from damage
Hose nozzle air suction regulator is open
Disconnect hose from used water tank
