Examples of 'inlet header' in a sentence
Meaning of "inlet header"
Inlet header: This phrase is commonly used in engineering and refers to a component that serves as an entry point for a fluid into a system, such as a pipe or duct
How to use "inlet header" in a sentence
Basic
Advanced
inlet header
Component cooling pump inlet header.
This common lower inlet header then directs such condensate to a drain.
A plurality of refrigerant tubes hydraulically connects the inlet header to the outlet header.
The inlet header defines a chamber for receiving liquid refrigerant from a refrigerant circuit.
The two or three tubular configurations each receives a feed of feedwater through an inlet header.
In particular, said inlet header tank is welded to said outlet tank.
Saturated steam a flows into the inlet header 1.
Fluid inlet header tank, and.
The membrane pipe wall tube is not connected to the inlet header 5.
However, the inlet header 20 is not limited to the depicted configuration.
One stream passes to the first stage reheater and is distributed through inlet header 58.
An inlet header for receiving liquid from the liquid / gas separator ;.
The SFC 's are installed in the tubing at the stub weld near the inlet header.
The inlet header 5 is in any suitable manner connected to each cooling tube 10 of a panel 4.
A fluid inlet 1 extends through a sidewall 40 of a vessel to provide fluid to the inlet header 3.
See also
FIG . 17 is a cutaway view of the inlet header with the distributor baffle / seal installed.
FIG . 13 is an end view of an exemplary distributor for insertion in the inlet header.
Fig . 8A is a perspective view showing the first inlet header 3 viewed from an outlet side.
The inlet header 400 is generally ring-shaped and defines a circular inlet passage.
A single tube is shown connected to inlet header 72 and outlet header 74.
The LNG inlet header 12 is also covered with a heat insulator jacket 18.
Fig . 2 shows a structure around the inlet header 1 and the outlet headers 5.
The LNG inlet header tank 12 is also covered with a heat insulator 18.
FIG . 9 is an end view of an inlet header.
FIGURE 3 is a sectioned view of the inlet header taken along the line B-B of Figure 2 ;.
FIG . 10 is an enlarged partial perspective view of the inlet header of FIG . 9.
You'll also be interested in:
Examples of using Inlet
Show more
Attach inlet and discharge hoses to pump
Check and clean inlet hose screen
Place inlet hoses inside washer basket
Examples of using Header
Show more
Header rotation speed and operating hours
Seems he took a header right after he was shot
Header or source file has not been created
