Examples of 'inlet temperature' in a sentence
Meaning of "inlet temperature"
Inlet temperature refers to the temperature of the air or fluid entering a system, such as a vehicle engine or a heating/cooling unit
How to use "inlet temperature" in a sentence
Basic
Advanced
inlet temperature
The inlet temperature and pressure are recorded.
Compartment and duct inlet temperature indicator.
The inlet temperature is controlled by a temperature sensor.
Te comp is the compressor inlet temperature.
Limit of air inlet temperature in the hardware.
Excess moisture is removed by increasing the inlet temperature.
Inlet temperature exceeding nominal temperature.
Flow rate is too high or inlet temperature is too low.
Water inlet temperature is too high.
Making the measuring method more precise evaporator inlet temperature.
The inlet temperature is identical for each bed.
The minimum and maximum inlet temperature is then limited.
Low inlet temperature is necessary due to fire risk.
This is very close to the inlet temperature of the superheated steam.
The inlet temperature should be kept as low as possible.
See also
Fourth filter means for filtering said command inlet temperature.
The gas inlet temperature depends on the solvent.
The temperature is preferably controlled at the inlet temperature prior to shearing.
An inlet temperature sensor is installed on the inlet duct flange.
For achieving a sufficiently high conversion a minimum inlet temperature is required.
Conventional inlet temperature estimations may not be sufficiently accurate.
A higher pressure may be offset or compensated by a yet higher inlet temperature.
The inlet temperature is conveniently computable by the following formula.
A sufficient number of locations shall be used to give a representative average inlet temperature.
Inlet temperature to the fabric filter in such combinations is important.
Coolant inlet temperature.
Inlet temperature of primary air.
Graco InSite upgradable will not include inlet temperature and pressure.
Check the inlet temperature differentials and verify they are sufficient.
The gas turbine performance increases with increasing turbine inlet temperature.
Air inlet temperature.
The horizontal exis in the figures is the inlet temperature to the catalyst.
Core inlet temperature.
A sufficient number of locations shall be used to give a representative average of the inlet temperature.
Inlet temperature of solid.
Therefore the oxidant gas inlet temperature of the several stacks will be different.
Inlet temperature gauge.
Shows the net efficiencies that can be obtained if the turbine inlet temperature.
The water inlet temperature is controlled by the combined cycle plant.
These functions are optimized with respect to the inlet temperature of heat addition process.
Cold water inlet temperature may be colder during the winter months.
This test result is in wide ranges independent from the water inlet temperature.
Preferably the water inlet temperature is as cold as can be obtained reasonably.
The second line of the display alternates between inlet temperature and inlet humidity.
The water inlet temperature must not exceed the nominal values.
Operation at high capacity will induce high pressure drop and a high inlet temperature.
This inlet temperature may be adjusted as a function of the nature of the feed.
The evaporation allows to cool the water to a temperature lower than the air inlet temperature.
The inlet temperature of the feed at each stage was substantially the same.
This ensures that the process gas is cooled to the correct shift converter inlet temperature.
You'll also be interested in:
Examples of using Temperature
Show more
Manufacturer of the separate temperature measuring equipment
Actual temperature below low temperature value
Select the desired temperature with and
Examples of using Inlet
Show more
Attach inlet and discharge hoses to pump
Check and clean inlet hose screen
Place inlet hoses inside washer basket
