Examples of 'orifice diameter' in a sentence
Meaning of "orifice diameter"
orifice diameter - the measurement of the size of an opening, typically referring to a hole or passage in the body or an object
How to use "orifice diameter" in a sentence
Basic
Advanced
orifice diameter
Burner orifice diameter is too small.
The two plates are mounted approximately one fine nozzle orifice diameter apart.
This number codes the orifice diameter and its correct burner location.
The stream velocities produced depend on the combination of flow rate and orifice diameter used.
Full power development - Orifice diameter correspond - ing to the flange nominal size.
In particular, a lower spray force value is favoured by a smaller orifice diameter.
Where d is the orifice diameter.
However, penetration depth can be controlled by the jet pressure and the orifice diameter.
The orifice diameter may be approximately 50 micrometers.
The chamber pressure is determined by the nozzle orifice diameter and grain burn rate.
Minimum orifice diameter measurements are performed using 100g samples of powder.
Said mixture was extruded on a single-screw extruder through a die having an orifice diameter of 5 mm.
Burner btu / hr orifice diameter color.
The method of Example 5 can be followed to determine the gravitational-flow minimum orifice diameter.
It is preferable that the orifice diameter be between 1 and 5 mm.
See also
Preferably, this distance is 2 to 5 times the minimum orifice diameter.
The tapered emitter can have an orifice diameter of 1.5 microns or less.
The orifice diameter should be at least 0.1 cm to accommodate this recharging action.
Tolerances during fabrication also frequently dictate that the orifice diameter be greater than about 5 mils.
The orifice diameter is 25 cm and the gauge is mounted approximately 0.6 m off the ground.
More preferably, different colors may be chosen for respectively indicating orifice diameter and engagement dimension.
The spinning nozzle had an orifice diameter of 3.8 mm and the spinning dope cell.
Particle diameters should be within 10 to 30 percent of the orifice diameter.
Fig . 4 is a graph that shows the, effect of orifice diameter and length on drug diffusion.
The throttle valve 344 comprises a solenoid type proportional valve having a maximum orifice diameter of φ1.7 mm.
A gravitational-flow minimum orifice diameter of less than about 20 mm ;.
The cans were provided with actuators with an orifice diameter of 0.22mm.
This corresponds to a test vessel orifice diameter of about 11 mm.
The single piece nozzle used for glue application had an orifice diameter of 0.012 inches.
Figure 2 shows that the exit orifice diameter 36 is about 3 mm.
ACL testing was performed using a Bespak actuator having an orifice diameter of 0.48 mm.
Swirl chamber diameter, tangential flow área, exit orifice diameter or length / diameter ratio.
The slurry was sprayed through a Schlick 2-fluid nozzle with an orifice diameter of 2.0 mm.
The low orifice actuator advantageously has an orifice diameter ranging from 0.2 mm to 0.4 mm.
The outlet seal surface 12c defines an orifice diameter O of the passageway 18.
You'll also be interested in:
Examples of using Diameter
Show more
A change in wire diameter results in changed parameters
Diameter of and pressure in the fire mains
The incoming hole diameter on auxiliary terminal
Examples of using Orifice
Show more
Install color coded orifice hoods supplied
A damaged orifice or regulator which requires replacement
Never remove threaded orifice at end of valve
