Examples of 'peel strengths' in a sentence
Meaning of "peel strengths"
peel strengths - identifying and highlighting individual strengths or qualities
Show more definitions
- plural of peel strength
How to use "peel strengths" in a sentence
Basic
Advanced
peel strengths
Peel strengths are an average of eight samples.
Table VI shows clearly that the peel strengths are insufficient.
The peel strengths after microwaving are only estimated.
These sample sets indicate the improved containment resulting from the higher Peak Wet Peel Strengths.
Peel strengths are recorded below.
The following peel strengths were observed,.
Peel strengths were then determined on each panel after the solder immersion.
For special applications, higher peel strengths can be achieved.
Higher peel strengths were obtained as the activated surface área decreased.
Details of formulations and peel strengths are set out in Table 3 below.
The peel strengths of the laminates prepared in this way are given below.
The change in the SAFT resistances and T peel strengths on aluminum are as follows,.
The peel strengths were very homogeneous and the heat aging was overall favorable.
Structures with > 35 % low adhesion sealant are also unable to deliver the same high peel strengths.
It is observed that the peel strengths obtained are maintained after crosslinking of the adhesive.
See also
IV values greater than 0.5 are generally associated with decreasing peel strengths.
The peel strengths reflect the fact that the protective coatings had a smooth finish without microtexture.
The following peel strengths were obtained, PRODUCT.
Peel strengths were measured on an Instron tester.
Suitable peel strengths are also discussed hereinbelow in the Example section.
Peel strengths are recorded in units of grams / cm.
Initial and aged peel strengths of the film laminants were measured and reported in Table 2.
The peel strengths of reflective films produced using the one-step process were tested.
Optimum peel strengths were realised with the BCP peeling layer from 1 to 3µm.
Peel strengths of resulting products are given in Table 3b . Table 3b.
Peel strengths ( kg / cm ) for different injection.
The reported peel strengths ( in N/100 mm ) are an average of three determinations except where noted.
Peel strengths are then determined using an Instron testing device at a peel rate of 5.08 cm / minute.
You'll also be interested in:
Examples of using Peel
Show more
Do not peel the fruit before drying
And then he will want me to peel a banana
Peel the onions and dice them
Examples of using Strengths
Show more
Analysis of strengths and weaknesses of the response
These organizations have their own strengths
Identify individual strengths and highlight them
