Examples of 'peel test' in a sentence
Meaning of "peel test"
The phrase 'peel test' refers to a method of evaluating the adhesion strength of a bonded material or coating by measuring its resistance to peeling or delamination. It involves applying a controlled force to separate two bonded surfaces and observing the peel resistance. Peel tests are often performed in manufacturing, quality control, and material testing procedures
How to use "peel test" in a sentence
Basic
Advanced
peel test
The complex is subsequently separated by a peel test.
Samples for the peel test were prepared as follows.
The sample was then subjected to a foam peel test.
Adhesion was measured by a tape peel test and visual inspection.
The coated substrates were also subjected to a peel test.
Both peeling test and crosscut peel test gave poor results.
Lamination strength of the bonding regions is measured using a peel test.
The peel test describes the permanence of adhesion or peelability of pressure sensitive adhesives.
The adhesive strength is measured using the peel test.
The higher the value for the climbing drum peel test the tougher the adhesive film.
It proved satisfactory in a peeling test but not in a crosscut peel test.
The peel strength is determined by a peel test performed on an Instron machine.
The quality of the adhesion is measured by a boiling water peel test.
Peel test Substrate for peel test and liquid media.
This join had been tested per peel test procedure.
See also
Peel test results are shown in Table III.
Cohesive adhesion to polypropylene is confirmed by the peel test as described above.
Peel test results comparing Madico film with Inventive Examples.
Turn on the pen and chart and start the peel test.
The peel test is suitably carried out using a Hounsfield Tensile Tester.
The bonding strength of the laminates produced was then measured by a peel test.
Next, a theoretical analysis of the peel test for an elastic-plastic material is proposed.
The samples were applied to skin the adhesive properties investigated by a peel test.
The adhesion has been evaluated by the manual peel test and the cross cut test.
A peel test using commercial pressure-sensitive tape was thereafter executed on the specimen.
The temperature of the oven is increased as in peel test until failure occurs.
The peel test is illustrated schematically in Figure 4.
The reference preparation is applied under the conditions of the peel test described.
The results of the peel test are shown in Table 3.
Some cohesive failure in the polyurethane foam took place during the peel test.
The results of peeling and crosscut peel test are given in Table 1.
Example 6 had poor peelability as shown by the two month hand peel test.
Peel Test The peel test is another, more subjective method of testing seam strength.
All three these tests effectively perform a peel test on the spot weld.
As a result, the peel test resulted in a ruptured MOF after short peels of about 1 cm.
The temperature of the oven was increased as in the peel test until failure occurred.
Shows a peel test specimen without reinforcing material before and after testing ; Figure 2.
The peeling test gave good result but the crosscut peel test did not.
The result of the peel test is given in N / cm.
Table XXV shows the results of the peel test.
The adhesion test is a modified peel test called the Quick Knife Adhesion ( QKA ) test.
Table XXI shows the results of the peel test.
The peel test is illustrated schematically in FIG . 4.
The peeling test showed it satisfactory but the crosscut peel test revealed a very slight peel.
EXAMPLE 1 The relative adhesion of creping adhesive compositions was measured by means of a peel test.
The peel test used a one hour contact time prior to pulling . Table 5.
The peeling test gave a satisfactory result but the crosscut peel test caused a very slight peel.
Then the initial peel test ( H-0 ) was performed on one series of samples at room temperature.
The UTI sensor arrangement was tested according to the peel test method hereinabove.
Peel test with tensile tester, Hounsfield model H5KS.
You'll also be interested in:
Examples of using Test
Show more
Mechanical tensile test prehoistable navigation lights
A test with tripping is compulsory on installation startup
Before the test we had art class
Examples of using Peel
Show more
Do not peel the fruit before drying
And then he will want me to peel a banana
Peel the onions and dice them
