Examples of 'retaining screw' in a sentence
Meaning of "retaining screw"
This phrase is used to describe a type of screw or fastener that is specifically designed to hold or secure something in place and prevent it from moving or being dislodged
How to use "retaining screw" in a sentence
Basic
Advanced
retaining screw
Use the retaining screw shown here.
Securely tighten the blade retaining screw.
Remove pivot and retaining screw under clincher blade.
Securely tighten the chuck retaining screw.
Remove the chuck retaining screw by turning it clockwise using a screwdriver.
Tighten the edge guide retaining screw.
The retaining screw may be worn or damaged and should be replaced.
Remove the chuck retaining screw by turning it.
Close battery holder and tighten retaining screw.
Replace the logset retaining screw into the ember bed.
Remove the rear exhaust duct retaining screw.
Put the retaining screw and washer in position and tighten.
Remove the heater assembly retaining screw.
Most are equipped with a retaining screw or clip to prevent accidental disconnection.
Secure heater assembly with retaining screw.
See also
The retaining screw is located just above the parking light.
Remove the casing retaining screw.
Remove the retaining screw in the bottom middle of the side broom.
Remove the needle by loosening the retaining screw.
Loosen retaining screw and remove sleeve nut along with die.
Order shown and tighten the retaining screw.
Loosen the retaining screw on magnet bracket and adjust the magnet alignment.
With the chuck retaining screw.
Unscrew the retaining screw that holds the battery cover in place and.
Secure by tightening small retaining screw.
The retaining screw then works between the screw foot and threads.
Switch is audible and tighten the retaining screw.
The retaining screw is screwed directly into an internal channel of the dental implant.
And secure it with the chuck retaining screw.
Loosen the support retaining screw located in the top front of the machines base.
Secure the belt hook with the retaining screw.
Loosen the base retaining screw with the wrench until the base can be moved.
Hinge holder back to cylinder and tighten retaining screw.
Remove the remote spool retaining screw and remote spool.
Replace the front cover h and tighten the retaining screw.
Beskrivelse: self retaining screw grmt nat.
Replace the cover and secure with the retaining screw.
Description: self retaining screw grmt nat.
Remove the hex wrench and replace the retaining screw.
Replace o-ring retaining screw and tighten firmly.
Replace the battery cover and refit the retaining screw.
Check that the blade 's retaining screw is correctly inserted.
Secure the cable ends with the cable drum retaining screw.
The retaining screw can only be undone - it can not be removed.
Remove the upper hinge after first removing the retaining screw.
Remove the chuck retaining screw by turning it clockwise left-hand thread.
Remove the cover from the power head and the retaining screw.
Re-tighten the base retaining screw with the wrench to secure the base.
Fit the tiller assembly on the rudder shaft and tighten the retaining screw.
Apply a drop of UHU schraubensicher to the retaining screw to prevent it working loose.
You'll also be interested in:
Examples of using Retaining
Show more
Do not run retaining straps over handles
Do not over tighten the retaining knobs
Recruiting and retaining qualified language staff
Examples of using Screw
Show more
Tighten the screw through the clips
Screw the two sections of pole together
Remove the screw on the rear coupler
