Examples of 'retaining screws' in a sentence
Meaning of "retaining screws"
Refers to screws or fasteners that are used to hold or secure a particular component or part in its place so that it doesn't move or detach
How to use "retaining screws" in a sentence
Basic
Advanced
retaining screws
Tighten the cover retaining screws securely.
Retaining screws and washers location.
Remove the hard drive retaining screws.
Loose the retaining screws on the hinges.
Lower seat plate and refit retaining screws.
Fit the retaining screws to secure the servos.
Remove the three retaining screws.
Check the retaining screws which fix the exhaust.
Remove both electrical box cover retaining screws.
Remove the two retaining screws of the cable connectors.
Firmly tighten both lower cap retaining screws.
Remove both retaining screws of the fixed guard cover.
Tighten the guide retaining screws.
Remove the two retaining screws of the cable protection cover then remove the cover.
Tighten the gear retaining screws.
See also
Fix the aileron and elevator servos to the fuselage framework using the retaining screws.
Loosen the guide retaining screws.
B Undo the retaining screws on the front cover and take the cover off the heater.
Remove fan assembly retaining screws.
A new bearing with four retaining screws will have to be purchased to replace existing bearing.
Secure by tightening small retaining screws.
Also check the retaining screws on the rotor blades.
In some embodiments the means comprise retaining screws.
Drill holes for the retaining screws and captive nuts in the nose bulkhead.
Install space bars and fix retaining screws.
The holes for the two retaining screws can now be drilled from above.
Remove the clamp bolt and the three retaining screws.
Remove the retaining screws of the terminal cover, if still in position.
Locate the keyboard retaining screws.
Insert the retaining screws ( supplied with the motor ) in the holes in the motor mounts.
Remove the keyboard retaining screws.
Remove the two retaining screws 1 from the memory compartment cover and lift the cover 2.
The mould was unclamped and the retaining screws removed.
Retaining screws, Use a screwdriver to unscrew the lamp module retaining screws.
Drill holes in the ailerons for the horn retaining screws.
Are the servo output arm retaining screws in place and tight?
Secure the starter assembly with the three retaining screws.
Remove the f ive handle-cover retaining screws on the right side of the handle.
Ensure front housing is securely fixed and insert the retaining screws.
Attach the servos using the retaining screws supplied with them.
Drill holes in the control surfaces for the horn retaining screws.
Replace the assemblies and retaining screws after the Self-Clean cycle has finished.
Individual burners can be replaced if necessary by removing the two retaining screws.
Fix the servo in place using the retaining screws supplied with it.
Reattach the shield plate to the circuit board and secure it with the retaining screws.
Fix the servos in place using the retaining screws supplied with them.
Using a phillips screwdriver, unscrew the white fluorescent bulb assemblies ' retaining screws.
Fix the motor to the firewall using the retaining screws supplied with the unit.
Affix the front plate by sliding it into place, inserting and tightening the retaining screws.
Drill pilot-holes for the retract unit retaining screws using the units themselves as templates.
You'll also be interested in:
Examples of using Screws
Show more
The screws are provided in the literature pack
Fully tighten screws with hex wrench
Screws are visible on the burner control panel
Examples of using Retaining
Show more
Do not run retaining straps over handles
Do not over tighten the retaining knobs
Recruiting and retaining qualified language staff
